Weider 8510 user manual Adjustment, Changing the Weight Setting

Page 17

ADJUSTMENT

The instructions below describe how each part of the home gym system can be adjusted. Refer to the exercise poster accompanying this manual to see how the home gym system should be set up for each exercise.

IMPORTANT: When attaching the lat bar or nylon strap, make sure that the attachments are in the cor- rect starting position for the exercise to be performed. If there is any slack in the cables or chain as an exercise is performed, the effectiveness of the exercise will be reduced.

CHANGING THE WEIGHT SETTING

To change the weight setting of the weight stack, insert a Weight Pin (26) under the desired Weight

(25). Be sure to insert the Weight Pin until the bent end of the Weight Pin is touching the Weights, and turn the bent end downward. The weight setting of the weight stack can be changed from 6.5 pounds to 81.5 pounds, in increments of 12.5 pounds. Note: Due to the cables and pulleys, the actual amount of resistance at each exercise station may vary from the weight setting. Use the WEIGHT RESISTANCE CHART on page 18 to find the actual amount of resistance at each weight station.

ATTACHING THE LAT BAR OR NYLON STRAP TO THE HIGH PULLEY STATION

Attach the Lat Bar (54) to the Long Cable (23) with a Cable Clip (53). For some exercises, the Chain (52) should be attached between the Lat Bar and the Long Cable with two Cable Clips. Adjust the length of the

Chain between the Lat Bar and the Long Cable so the Lat Bar is in the correct starting position for the exercise to be performed.

The Nylon Strap (39) (not shown) can be attached in the same manner.

ATTACHING THE LAT BAR OR NYLON STRAP TO THE LOW PULLEY STATION

Attach the Lat Bar (54) to the Short Cable (58) with a Cable Clip (53). For some exercises, the Chain (52) should be attached between the Lat Bar and the Pulley Cable with two Cable Clips. Adjust the length of the Chain between the Lat Bar and the Short Cable so the Lat Bar is in the correct starting position for the exercise to be performed.

The Nylon Strap (39) (not shown) can be attached in the same manner.

25

26

53

23

52

54

58

53

52 54

17

Image 17
Contents Model No. WESY85101 Serial No QUESTIONS?Customer HOT Line Patent PendingLimited Warranty Table of ContentsImportant Precautions Before YOU Begin Assembled DimensionsFollowing Tools not Included are Required for Assembly AssemblyChart located in the center of this manual Tighten all Nylon Locknuts used in steps 1 through Nylon Locknuts yetIndicated tube in the Base. Be sure Plastic Bushings should fit onto each endThat the pulleys are on the indicated side ARMImportant for step On each Arm. Arm identification is veryArm with the Left Arm 47 refer to step To identify the Right Arm. Be sure thatCable Assembly Cable Assembly Crossbar From other side Inset shows viewCable Assembly Pivot freely Locknut 3. Do not overtighten the NylonLocknut. The Leg Lever must be able to Seat Assembly High Pulley Butterfly Changing the Weight Setting AdjustmentAttaching the LEG Lever to the LOW Pulley Station Weight Resistance ChartAttaching and Removing the Seat Tightening the Cables TROUBLE-SHOOTING and MaintenanceShort Cable Cable DiagramLong Cable 23 TOP View Page Key No. Qty Description Part LISTÑModel No. WESY85101Exploded DRAWINGÑModel No. WESY85101 Page Page Page Ordering Replacement Parts