Weider 8510 user manual Seat Assembly

Page 15

SEAT ASSEMBLY

29.Rest the Seat Frame (36) on the indicated pin in the Front Upright (42). Attach the Seat Frame to the Front Upright with a 5/16Ó x

2 3/4Ó Carriage Bolt (14) and the Seat Knob

(40).

30.Press 3/4Ó Round Inner Caps (34) into the ends of both 12 1/2Ó Pad Tubes (28).

Insert one 12 1/2Ó Pad Tube (28) into the Seat Frame (36). Slide a 5 1/2Ó Pad (30) onto each end of the Pad Tube.

Insert the other 12 1/2Ó Pad Tube (28) into the Leg Lever (29). Slide a 5 1/2Ó Pad (30) onto each end of the Pad Tube.

29

40

36

14

Pin

42

30

36	30
36	34
	28

34

30

29

15

Image 15

Contents Patent Pending QUESTIONS?Model No. WESY85101 Serial No Customer HOT LineLimited Warranty Table of ContentsImportant Precautions Before YOU Begin Assembled DimensionsAssembly Chart located in the center of this manualFollowing Tools not Included are Required for Assembly Tighten all Nylon Locknuts used in steps 1 through Nylon Locknuts yetARM Plastic Bushings should fit onto each endIndicated tube in the Base. Be sure That the pulleys are on the indicated sideTo identify the Right Arm. Be sure that On each Arm. Arm identification is veryImportant for step Arm with the Left Arm 47 refer to stepCable Assembly Cable Assembly Crossbar From other side Inset shows viewCable Assembly Locknut 3. Do not overtighten the Nylon Locknut. The Leg Lever must be able toPivot freely Seat Assembly High Pulley Butterfly Changing the Weight Setting AdjustmentWeight Resistance Chart Attaching and Removing the SeatAttaching the LEG Lever to the LOW Pulley Station Tightening the Cables TROUBLE-SHOOTING and MaintenanceCable Diagram Long Cable 23 TOP ViewShort Cable Page Key No. Qty Description Part LISTÑModel No. WESY85101Exploded DRAWINGÑModel No. WESY85101 Page Page Page Ordering Replacement Parts