19.Note: This assembly step shows how to complete the assembly of several pre- attached parts.
The 5/8Ó x 9/16Ó Spacer (73) has been pre- attached on the outside of the 3 1/2Ó Low Pulley (77) for shipping purposes. Remove the 3/8Ó Nylon Locknut (21), the Spacer, and the Pulley from the 3/8Ó x 3 3/4Ó Bolt (71). Do not remove the Bolt. The Bolt has been shown removed for part identification.
Reattach the 3 1/2Ó Low Pulley (77), with the 5/8Ó x 9/16Ó Spacer (73) between the Pulley and the Press Frame (17). Do not tighten the 3/8Ó Nylon Locknut (21) yet. Be sure that the 3/8Ó x 3 3/4Ó Bolt (71), the 3/8Ó Flat Washer (9), the 5/8Ó x 9/16Ó Spacer (73), the 3 1/2Ó Low Pulley (77), and the 3/8Ó Nylon Locknut (21) are oriented as shown.
19
9 | 71 |
|
73
17 | 77 |
| 21 |
CABLE ASSEMBLY
20.Locate the Short Cable (58). Route the Short Cable (58) under the 3 1/2Ó Low Pulley (77). Be sure that the end of the Cable with the ball is on the indicated side of the Press Frame (17) and that the Cable is between the Pulley and the crossbar on the Press Frame. Tighten the 3/8Ó Nylon Locknut (21) and the 3/8Ó x 3 3/4Ó Bolt (not shown).
20 |
58
21 
17
77
Ball |
Crossbar
11