Inset shows view, From other side | Weider 8920 instruction

19. Slide two Cable Traps (66) and two 90mm	19
Pulleys (15) onto two M10 x 90mm Bolts (16).	19
Pulleys (15) onto two M10 x 90mm Bolts (16).	42	16
Insert the Bolts into the Front Upright (42) from	42	16
Insert the Bolts into the Front Upright (42) from		66
the direction shown. Hand tighten an M10 Nylon		66
the direction shown. Hand tighten an M10 Nylon		15
Locknut (21) with an M10 Washer (9) onto each		15
Locknut (21) with an M10 Washer (9) onto each
Bolt. Be sure that all parts are oriented as	9
shown. Do not tighten the Nylon Locknuts yet.	9		16
	21	15	66
20. Route the Short Cable (23) around the 90mm	20	42
Pulley (15) attached to the lower hole in the Front	20

	42		15
Upright (42). See the inset drawing. Be sure	42		15
that the Cable Trap (66) is turned to hold the	15	16
Cable in place. Properly tighten the M10 Nylon	15	16
Cable in place. Properly tighten the M10 Nylon
Locknut (21) and the M10 x 90mm Bolt (16).	21
	21		66
		23	66
		23
		23
		Inset shows view
		from other side
21. Route the Short Cable (23) around the 90mm	21	42
Pulley (15) attached to the upper hole in the	21
Pulley (15) attached to the upper hole in the
Press Frame (17). Be sure that the Cable Trap		15
(66) is turned to hold the Cable in place.		15
(66) is turned to hold the Cable in place.
Properly tighten the M10 Nylon Locknut (21)		16
Route the Short Cable (23) around the 90mm			66
Pulley (15) attached to the upper hole in the Front		23
Upright (42). Refer to the inset drawing. Be		23
Upright (42). Refer to the inset drawing. Be		42
sure that the Cable Trap (66) is turned to hold		42
sure that the Cable Trap (66) is turned to hold		Inset shows view
the Cable in place. Properly tighten the M10		Inset shows view
Nylon Locknut (21) and the M10 x 90mm Bolt		from other side
(16).		23
		23
		15
	15	66
		66
	21	21
		21
		17

Inset shows view

from other side