Weider 8920 user manual Each Carriage Bolt. Do not tighten the Nylon Locknuts yet

2. Refer to drawing 2a. Press a 25mm Round Inner	2		2a	70		49
Cap (49) into each end of the weight tube on the
		19
Weight Carriage (19). Note: Make sure the				19
						70
Square Slider Bushings (70) are assembled to			49
the Weight Carriage and Weight Stop (67).		70
Turn the Weight Stop (67) so that the indicated		67	Hole	70		67
hole is on the side shown and the Square Slider
Bushing (70) is on top. Slide the Weight Stop
onto the Rear Upright (56).
Refer to drawing 2b. Attach the Weight Stop		56	42
(67) to the Rear Upright (56) with an M8 x 70mm
Bolt (11) and an M8 Nylon Locknut (3).
Orient the Weight Carriage (19) as shown. Slide
the Weight Carriage onto the Rear Upright (56).
					65
Press a 25mm Square Inner Cap (65) into the
Front Upright (42). Slide the Front Upright onto
the M8 x 63mm Carriage Bolts (1) in the Base
(4). Hand tighten an M8 Nylon Locknut (3) onto			3
each Carriage Bolt. Do not tighten the Nylon	2b	56
Locknuts yet.
				4
	19
		67
			1
	3		11
3. Press a 50mm Square Inner Cap (27) into the top
of the Rear Upright (56). Press a 45mm Square	3
Inner Cap (44) into each end of the crossbar on				61
the Top Frame (55). Press two 25mm Round			55
					49
Inner Caps (49) into the top of the crossbar.
			8			44
Attach the Top Frame (55) to the Front Upright		27
(42) with two M8 x 67mm Bolts (61), a Support		8
Plate (8), and two M8 Nylon Locknuts (3). Attach			3			Crossbar
the Top Frame to the Rear Upright (56) in the	61			44
same manner.
Tighten the Nylon Locknuts used in steps 1–3.		56	3	42
ARM ASSEMBLY
	4
4. Press a 25mm Plastic Bushing (26) onto each
welded spacer on the Press Frame (17). Slide the
Press Frame onto the Base (4) so the Plastic						Lubricate
Bushings are aligned with the indicated tube in			17
the base. Note: This will be a tight fit; the
Plastic Bushings should fit over the ends of						59
the tube in the Base.			21			9
Lubricate an M10 x 198mm Bolt (59). Attach the	4				Welded
					Spacers
Press Frame (17) to the Base (4) with the Bolt, two		Tube
			9
M10 Washers (9), and an M10 Nylon Locknut (21).				26
Note: Do not overtighten the Nylon Locknut;
the Press Frame must be able to pivot easily.
	6