Weider 8920 user manual

Page 14

27.Press two 19mm Round Inner Caps (34) into the ends of both Pad Tubes (28).

Insert one Pad Tube (28) into the Seat Frame (36). Slide a Foam Pad (30) onto each end of the Pad Tube.

Insert the other Pad Tube (28) into the Leg Lever (29). Slide a Foam Pad (30) onto each end of the Pad Tube.

27

36

30

34

28

34

30

29

28.Make sure that all parts have been properly tightened. The use of all remaining parts will be explained in ADJUSTMENT, beginning on page 15 of this manual.

Before using the weight system, pull each cable a few times to make sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly routed, they may be damaged when heavy weight is used. See the CABLE DIAGRAM on page 19 of this manual for proper cable routing. If there is any slack in the cables, you will need to remove it by tightening the cables; see TROUBLE-SHOOTING AND MAINTE- NANCE on page 18.

14

Image 14
Contents Model No Serial No SEARS, Roebuck and CO. Hoffman ESTATES, ILTable of Contents Important Precautions For your benefit, read this manual carefully before Using the Weider 8920 weight system. If you haveBefore YOU Begin Assembly Make Things Easier for YourselfPress Frame must be able to pivot easily Each Carriage Bolt. Do not tighten the Nylon Locknuts yetTighten the Nylon Locknuts used in steps Arm. Arm identification is important for step FrameCable Assembly Page Locate the Short Cable 23. Route the Short Inset shows view From other sideSeat Assembly Tighten the Nylon Locknut the Leg Lever Must pivot freelyPage Attaching the LAT BAR or Nylon Strap to a Pulley Station AdjustmentAdding Weights to the Weight Carriage Attaching and Removing the Seat Attaching the LEG Lever to the LOW Pulley StationLbs Weight Resistance ChartWeight Press ARM Butterfly ARM LOW Pulley High Pulley LEG LeverTROUBLE-SHOOTING and Maintenance Tightening the CablesTOP View Cable DiagramLong Cable Short CableExercise Guidelines Staying Motivated Muscle ChartCooling Down Part Identification CHART-Model No .159711 R0102A Page Pulley 90mm Pulley Not shown to scale Part LIST-Model No Qty DescriptionExploded DRAWING-Model No SEARS, Roebuck and CO., Hoffman ESTATES, IL Full 90 DAY WarrantyModel No SEARS, Roebuck and CO., Dept WA, Hoffman ESTATES, IL