Weider 8920 user manual TROUBLE-SHOOTING and Maintenance, Tightening the Cables

Page 18

TROUBLE-SHOOTING AND MAINTENANCE

Make sure all parts are properly tightened each time you use the weight system. Replace any worn parts immedi- ately. The weight system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.

TIGHTENING THE CABLES

Woven cable, the type of cable used on the weight system, can stretch slightly when it is first used. If there is slack in the cables before resistance is felt, the cables should be tightened.

Slack can be removed from the Short Cable (23) by by tightening the M8 Nylon Locknut (3) at the end of the Cable.

Additional slack can be removed by moving the 90mm Pulley (15) to the other hole in the Long “U”- Bracket (57). Remove the M10 Nylon Locknut (21) and the M10 x 45mm Bolt (12) from the Cable Trap (66), the Pulley, and the “U”-Bracket. Re-attach the Pulley and the Cable Trap to the other hole in the “U”- Bracket with the Bolt and Nylon Locknut. Make sure that the Cable Trap is in the proper position and that the Cable and Pulley move smoothly.

Note: If a cable tends to slip off the pulleys, the cable may have become twisted. Remove the cable and re-install it. If a cable needs to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this manual.

66

15

 

21

57

12

 

3

23

18

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Model No Serial No SEARS, Roebuck and CO. Hoffman ESTATES, ILTable of Contents Important Precautions Using the Weider 8920 weight system. If you have Before YOU BeginFor your benefit, read this manual carefully before Assembly Make Things Easier for YourselfEach Carriage Bolt. Do not tighten the Nylon Locknuts yet Tighten the Nylon Locknuts used in stepsPress Frame must be able to pivot easily Arm. Arm identification is important for step FrameCable Assembly Page Locate the Short Cable 23. Route the Short Inset shows view From other sideSeat Assembly Tighten the Nylon Locknut the Leg Lever Must pivot freelyPage Adjustment Adding Weights to the Weight CarriageAttaching the LAT BAR or Nylon Strap to a Pulley Station Attaching and Removing the Seat Attaching the LEG Lever to the LOW Pulley StationLbs Weight Resistance ChartWeight Press ARM Butterfly ARM LOW Pulley High Pulley LEG LeverTROUBLE-SHOOTING and Maintenance Tightening the CablesTOP View Cable DiagramLong Cable Short CableExercise Guidelines Muscle Chart Cooling DownStaying Motivated Part Identification CHART-Model No .159711 R0102A Page Pulley 90mm Pulley Not shown to scale Part LIST-Model No Qty DescriptionExploded DRAWING-Model No SEARS, Roebuck and CO., Hoffman ESTATES, IL Full 90 DAY WarrantyModel No SEARS, Roebuck and CO., Dept WA, Hoffman ESTATES, IL
Top Page Image Contents