Weider 8920 user manual Seat Assembly

Page 12

22. Attach the end of the Short Cable (23) to the	22
Long “U”-Bracket (57) with an M8 Nylon Locknut	22
Long “U”-Bracket (57) with an M8 Nylon Locknut
(3) and an M8 Washer (68). Do not completely
tighten the Nylon Locknut; it should be
threaded onto the end of the Cable until two
threads are showing above the Nylon
Locknut, as shown in the inset drawing.
	3
	68	57
		23
		3
		68
	57	23
SEAT ASSEMBLY	23
SEAT ASSEMBLY
23. Attach the Backrest (41) to the Front Upright (42)
with two M6 x 63mm Screws (43) and two M6
Washers (10).
		42
		41
		43 10

12

Image 12

Contents Model No Serial No SEARS, Roebuck and CO. Hoffman ESTATES, ILTable of Contents Important Precautions Using the Weider 8920 weight system. If you have Before YOU BeginFor your benefit, read this manual carefully before Assembly Make Things Easier for YourselfEach Carriage Bolt. Do not tighten the Nylon Locknuts yet Tighten the Nylon Locknuts used in stepsPress Frame must be able to pivot easily Arm. Arm identification is important for step FrameCable Assembly Page Locate the Short Cable 23. Route the Short Inset shows view From other sideSeat Assembly Tighten the Nylon Locknut the Leg Lever Must pivot freelyPage Adjustment Adding Weights to the Weight CarriageAttaching the LAT BAR or Nylon Strap to a Pulley Station Attaching and Removing the Seat Attaching the LEG Lever to the LOW Pulley StationWeight Resistance Chart Weight Press ARM Butterfly ARM LOW Pulley High PulleyLbs LEG LeverTROUBLE-SHOOTING and Maintenance Tightening the CablesCable Diagram Long CableTOP View Short CableExercise Guidelines Muscle Chart Cooling DownStaying Motivated Part Identification CHART-Model No .159711 R0102A Page Pulley 90mm Pulley Not shown to scale Part LIST-Model No Qty DescriptionExploded DRAWING-Model No Full 90 DAY Warranty Model NoSEARS, Roebuck and CO., Hoffman ESTATES, IL SEARS, Roebuck and CO., Dept WA, Hoffman ESTATES, IL