Weider WESY19611 user manual Arm. Arm identification is very important for Step, Nylon Locknut yet

8.	Press a 1 3/4” Square Inner Cap (44) into the top	8			44
	of a Press Arm (46). Press a 1” Round Inner Cap
	(49) into the handle on the Press Arm.					49
	Attach the Press Arm (46) to one side of the
	Press Frame (17) with two 5/16” x 2 1/2” Bolts
	(22) and two 5/16” Nylon Locknuts (3).					46
	Assemble the other Press Arm (46) in the same	46	22
	manner.
					3
					17
9.	Identify the Right Arm (48) and the Left Arm (47).	9		7	50
	Note the position of the welded bracket on each
	Arm. Arm identification is very important for		50		6
	step 10.
			6
	Attach a “V”-Pulley (6) and a Long Cable Trap				21	47
	(50) to the Right Arm (48) with a 3/8” x 2 1/2” Bolt
	(7) and a 3/8” Nylon Locknut (21). Do not tighten		21		Welded
	the Nylon Locknut yet.			Brackets
	Attach a “V”-Pulley (6) and a Long Cable Trap	48
	(50) to the Left Arm (47) in the same way.
10.	Lubricate both axles on the Top Frame (55). Slide	10
	the Right Arm (48) onto the right axle. Note: Be			55
						47
	careful not to confuse the Right Arm with the
	Left Arm (47); refer to step 9 to identify the
	Right Arm. Make sure that the upper end of
	the Right Arm is behind the indicated bracket
	on the Top Frame.			Bracket
	Tap two 1” Retainers (69) and a 1” Round Cover	48			Lubricate	45
	Cap (70) onto the right axle. Make sure that the
					Axles
	teeth on the Retainers bend toward the Cover			69
	Cap, as shown in the inset drawing.
				70
	Attach the Left Arm (47) in the same manner.
	Press two 1 3/4” Square Inner Caps (44) into the
	lower ends of the Right and Left Arms (47, 48).
	Wet the lower end of each Arm with soapy water.
	Slide a 10” Pad (45) onto the lower end of each
	Arm.
		44
		45			55
						69
						70
		8