11.Press a 1 3/4” Square Inner Cap (44) into the Seat Frame (36). Attach a Bumper (73) to the Seat Frame with a #8 x 3/4” Tap Screw (65).
Slide the Seat Frame (36) onto the 5/16” x 2 1/2” Carriage Bolts (1) in the Base (4). See the inset drawing. The indicated bracket on the Seat Frame must be behind the Press Frame (17).
Hand tighten a 5/16” Nylon Locknut (3) onto each Carriage Bolt. Do not tighten the Nylon Locknuts yet.
Attach the Seat Frame (36) to the Front Upright
(42)with two 5/16” x 2 3/4” Bolts (11), two 5/16” Washers (8), and two 5/16” Nylon Locknuts (3).
Tighten the four 5/16” Nylon Locknuts (3) used in this step.
12.Attach a Bumper (73) to the Rocker Arm (32) with a #8 x 3/4” Tap Screw (65).
Lubricate a 3/8” x 3 1/4” Bolt (68). Attach the Rocker Arm (32) to the Base (4) with the Bolt and a 3/8” Nylon Locknut (21). Do not overtighten the
Nylon Locknut; the Rocker Arm must be able to pivot freely.
13.Press a 1 3/4” Square Inner Cap (44) into each end of the Leg Lever (29).
Lubricate a 3/8” x 2 1/2” Bolt (7). Attach the Leg Lever (29) to the Rocker Arm (32) with the Bolt and a 3/8” Nylon Jamnut (33). Do not overtighten the
Nylon Jamnut; the Leg Lever must be able to pivot freely.
9
11 |
|
|
|
| Bracket |
| 36 |
|
|
| |
| 17 |
|
|
42 |
|
|
|
8 |
|
|
|
|
| 44 | |
11 |
|
|
|
8 |
|
| 73 65 |
3 | 36 |
| |
|
| ||
17 |
| 3 | 3 |
|
| ||
|
|
| |
4 |
|
|
|
1 |
|
|
|
12 |
|
|
|
| 73 |
|
|
| 65 |
|
|
32 |
|
|
|
|
| 68 |
|
21 |
| Lubricate | |
|
| ||
4 |
|
|
|
13 | 44 |
| 7 |
|
| ||
32 |
|
| Lubricate |
|
|
| |
| 33 |
|
|
|
|
| 29 |
| 44 |
|
|