Weider WESY19740 user manual Frame Assembly, Locknuts yet

Page 6

1.

Frame Assembly

Before beginning assembly, make sure you understand the information in the box on page 5. Refer to the PART IDENTIFICATION CHART in the center of this manual for help identifying small parts.

1

1

78

Insert four M8 x 63mm Carriage Bolts (78) up through the Base (1). Note: It may be helpful to place a piece of tape over the bolt heads to hold them in place.

2.Attach the Base (1) and the two Weight Guides (21) to the Stabilizer (2) with two M10 x 67mm Bolts (71), two M10 Washers (57), and two M10 Nylon Locknuts (56). Make sure the indicated holes in the Weight Guides are nearer the bot- tom. Fully tighten the Locknuts.

Attach the Upright (3) to the Base (1) with the indicated two M8 x 63mm Carriage Bolts (78) and two M8 Nylon Locknuts (58). Do not tighten the

Locknuts yet.

	78
2
	Holes
	21
	21
3
	57	56
58	71	57
58
	71	2
1	71
1
78

6

Image 6

Contents QUESTIONS? Model No. WESY19740 Serial NoCustomer HOT Line Table of Contents Important Precautions Before YOU Begin Left SideRight Side Assembly Make Assembly Easier for YourselfFrame Assembly Locknuts yetLocknut yet Bumper is pointing upTube is oriented as shown Locknuts yet Arm Assembly Cable Assembly Assemble the Left Arm 10 in the same mannerPage Locate the Low Cable 53. Route the Cable Sure the Finger Guards are on the outside Bracket as shown Page Seat Assembly Page Attaching the Accessories to a Pulley Station AdjustmentsChanging the Weight Setting Using the Lock LeverUsing the Curl PAD Locking the Weight StackARM Conversion Weight Resistance Chart Weight High Butterfly Press ARM LEG Lever LOW PulleyLbs Arm Cable Cable DiagramsHigh Cable Low CableMaintenance Tightening the CablesExercise Guidelines Muscle Chart Cooling DownStaying Motivated Part Identification Chart Part LIST-Model No. WESY19740 Qty DescriptionExploded DRAWING-Model No. WESY19740 41 57 Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT