Weider WESY19740 user manual Sure the Finger Guards are on the outside Bracket as shown

22. Route the Low Cable (53) under a 90mm Pulley		22
	(48). Attach the Pulley and two Half Finger
	Guards (43) to the Base (1) with an M10 x 46mm		56	43
	Bolt (81) and an M10 Nylon Locknut (56). Make					53
	sure the Finger Guards are on the outside of
	the bracket as shown.					48
							81
					1	43
23. Attach the Low Cable (53) to the “U”-bracket (45)		23
	with an M8 Washer (59) an an M8 Nylon Locknut
	(58). See the inset drawing. Do not overtighten
	the Locknut; it should be threaded onto the
	end of the Cable so that only two threads are
	showing above the nut.
			58		58
							45
					59
		45	53		53
24. Locate the High Cable (55). Route the Cable up		24
	through the Top Frame (4) and over a 90mm
	Pulley (48). Attach the Pulley inside of the Top				55
	Frame with an M10 x 67mm Bolt (71), two M10
						4
	Washers (57), two 12mm Spacers (52), and an			57
						48
	M10 Nylon Locknut (56).
				56
						52
				52			71
						57
25.	Route the High Cable (55) over a 90mm Thin	25
	Pulley (47) and down through the Top Frame (4).
	Attach the Pulley inside of the Top Frame with an						47
	M10 x 67mm Bolt (71), an M10 Washer (57), and
					55
	an 11mm Spacer (49). Make sure that the						4
	Pulley does not fall out of the Top Frame while
	completing steps 26 and 27.
						49	57 71
		13