Do not tighten the Nylon Locknut yet | Weider PRO 9400 manual

ARM ASSEMBLY

12.Press a 1Ó Round Inner Cap (49) into one of the Press Arms (46). Press a 1 3/4Ó Square Inner Cap (44) into the Press Arm.

Attach the Press Arm (46) to one side of the Press Frame (17) with two 5/16Ó x 2 1/2Ó Bolts (22) and two 5/16Ó Nylon Locknuts (3).

Assemble the other Press Arm (46) in the same manner.

13.Identify the Right Arm (48) and the Left Arm

(47).Note the position of the welded bracket on each Arm. Arm identification is very important for step 14.

Attach a ÒVÓ-Pulley (50) and a Long Cable Trap (31) to the Right Arm (48) with a 3/8Ó x

2 1/2Ó Bolt (86) and a 3/8Ó Nylon Locknut (21).

Do not tighten the Nylon Locknut yet.

Attach a ÒVÓ-Pulley (50) and a Long Cable Trap (31) to the Left Arm (47) in the same manner.

14.Lubricate both axles on the Top Frame (55).

Slide the Right Arm (48) onto the right axle.

Note: Be careful not to confuse the Right Arm with the Left Arm (47); refer to step 13 to identify the Right Arm. Be sure that the upper end of the Right Arm is behind the indicated bracket on the Top Frame (55).

See the inset drawing. Tap two 1Ó Retainers

(69)and a 1Ó Round Cover Cap (70) onto the axle. Be sure that the teeth on the

Retainers bend toward the Round Cover Cap, as shown.

Attach the Left Arm (47) in the same manner.

Press 1 3/4Ó Square Inner Caps (44) into the lower ends of the Right and Left Arms (47, 48). Wet the lower end of each Arm with soapy water. Slide a 10Ó Pad (45) onto the lower end of each Arm.

12		44	49
			49
			46
	22
46
		3
		17
13	86	31
	31	50
	31
Welded	50		47
Welded			47
Brackets
		21
48
14
	55	Bracket
			47
		Lubricate
		Axle
	48
		69
			45
		70
			44
	44	Axle
	45		69
			70