FRAME ASSEMBLY
ARM ASSEMBLY
5.Press the Weight Tube Bumper (64) into the end of the Weight Tube (63). Lubricate the insides of the holes in the Top Weight (76). Insert the Weight Tube into the stack of Weights (25).
Insert both Weight Guides (62) into the stack of Weights (25). Be sure that the indicated holes in the Weight Guides are at the top.
6.Attach the upper ends of the Weight Guides (62) to the Top Frame (55) with the 5/16Ó x 6 1/2Ó Bolt (60), two 1/2Ó x 1Ó Spacers (61), and a 5/16Ó Nylon Locknut (3).
7.Press a 1Ó x 7/8Ó Plastic Bushing (75) onto each welded spacer on the Press Frame (17). Slide the Press Frame into place on the Base
(4). Note: This will be a tight fit. The
Plastic Bushings should fit on each end of the indicated tube in the Base. Be sure that the Press Frame is oriented as shown.
Lubricate the 3/8Ó x 8Ó Bolt (59). Attach the Press Frame (17) to the Base (4) with the 3/8Ó x 8Ó Bolt and a 3/8Ó Nylon Locknut (21).
7
5 |
|
| Holes |
| 62 |
Lubricate | 76 |
| |
| 63 |
| 64 |
25 |
|
6 |
|
| 61 |
55 |
|
| 3 |
60 |
|
62 |
|
7 |
|
| 17 |
| 85 |
| 59 |
4 | Lubricate |
21 | |
| Welded |
Tube | Spacers |
75 |