Weider XR20 user manual Adjustment, Changing the Weight Setting

Page 17

ADJUSTMENT

The instructions below describe how each part of the home gym system can be adjusted. Refer to the exercise guide accompanying this manual to see how the home gym system should be set up for each exercise. IMPOR-

TANT: When attaching the lat bar or nylon strap, make sure that the attachments are in the correct start- ing position for the exercise to be performed. If there is any slack in the cables or chain as an exercise is performed, the effectiveness of the exercise will be reduced.

CHANGING THE WEIGHT SETTING

To change the weight setting of the weight stack, insert the Weight Pin (26) under the desired Weight (25). Be sure to insert the Weight Pin until the bent end of the Weight Pin is touching the Weights, and turn the bent end downward. The weight setting of the weight stack can be changed from 6.5 pounds to 96.5 pounds, in increments of 10 pounds. Note: Due to the cables and pulleys, the actual amount of resistance at each exercise station may vary from the weight setting. Use the WEIGHT RESISTANCE CHART on page 19 to find the actual amount of resistance at each weight station.

ATTACHING THE LAT BAR OR NYLON STRAP TO THE HIGH PULLEY STATION

Attach the Lat Bar (54) to the Long Cable (23) with a Cable Clip (53). For some exercises, the Chain (52) should be attached between the Lat Bar and the Long Cable with two Cable Clips. Adjust the length of the

Chain between the Lat Bar and the Long Cable so the Lat Bar is in the correct starting position for the exercise to be performed.

The Nylon Strap (39) can be attached in the same manner.

ATTACHING THE LAT BAR OR NYLON STRAP TO THE LOW PULLEY STATION

Attach the Lat Bar (54) to the Medium Cable (58) with a Cable Clip (53). For some exercises, the Chain (52) should be attached between the Lat Bar and the Medium Cable with two Cable Clips. Adjust the length of the Chain between the Lat Bar and the Medium Cable so the Lat Bar is in the correct starting position for the exercise to be performed.

The Nylon Strap (39) can be attached in the same manner.

25

 

26

 

 

53

23

 

52

 

 

39

 

54

58

 

53

52

 

 

53

54

39

17

Image 17
Contents Customer HOT Line QUESTIONS?Model No. WESY01190 Serial No Limited Warranty Table of ContentsImportant Precautions Before YOU Begin Assembled DimensionsFrame Assembly AssemblyChart located in the center of this manual Following Tools not Included are Required for AssemblyLocknuts yet Frame Assembly ARM Assembly Indicated bracket on the Top Frame Arm with the Left Arm 47 refer to stepCable Assembly Cable Assembly Make sure that the Cable Trap Pulley are oriented as shown From other side Locate the Medium Cable 58. RouteInset shows view Cable Assembly Seat Assembly Seat Assembly Cable 35 and the Curl Bar 77 as shown LEG Lever Assembly Curl Frame AssemblyPage Changing the Weight Setting AdjustmentAttaching and Removing the Seat Using the Curl BARAttaching the LEG Lever to the LOW Pulley Station Attaching and Removing the Curl FrameWeight Resistance Chart Adjusting the Short CableTightening the Cables TROUBLE-SHOOTING and MaintenanceLong Cable Cable DiagramTOP View Medium CablePage Page Page Key No. Qty Description Part LISTÑModel No. WESY01190Exploded DRAWINGÑModel No. WESY01190 Ordering Replacement Parts