16.Wrap the Short Cable (9) around a 3 1/2Ó Pulley (35) in the direction shown.
Attach the 3 1/2Ó Pulley (35) and a Cable Trap (66) to the Left Butterfly Arm (47) with a 3/8Ó x 2Ó Bolt (62) and a 3/8Ó Nylon Locknut (63).
Make sure the Cable Trap (66) is positioned as shown.
Route the Short Cable (9) under the Top Frame (1) between the Pulley (35) and the crossbar.
17.Move to the other side of the unit. Wrap the Short Cable (9) around a 3 1/2Ó Pulley (35) in the direction shown.
Attach the 3 1/2Ó Pulley (35) and a Cable Trap (66) to the Right Butterfly Arm (48) with a 3/8Ó x 2Ó Bolt (62) and a 3/8Ó Nylon Locknut (63).
Make sure the Cable Trap (66) is positioned as shown.
18.Remove the 1/2Ó Nylon Locknut (68) from the welded bolt (L) on the Top Frame (1). Slide the Pulley Bracket (20) onto the bolt and secure it with the Nylon Locknut. Tighten the Locknut, but make sure the Pulley Bracket can pivot freely.
Remove the 3 1/2Ó Pulley (35) from the Pulley Bracket (20). Wrap the Short Cable (9) around the Pulley in the direction shown.
(20)with the 3/8Ó x 1 3/4Ó Bolt (83) and the 3/8Ó Nylon Jamnut (57).
19.Move to the other side of the unit. Remove the 3 1/2Ó Pulley (35) attached to the Pulley Plates (31).
Wrap the Short Cable (9) around the 3 1/2Ó Pulley
(35)in the direction shown.
16 |
| 1 |
9 | 66 | 62 |
| ||
Crossbar |
|
|
|
| 35 |
63 |
| |
|
| 47 |
17 |
|
|
66 | 62 | |
|
| |
9 |
| 35 |
|
| |
|
| 63 |
|
| 48 |
18 |
| 1 |
|
| |
L |
|
|
20 |
| 83 |
57 |
|
|
68 |
|
|
35 |
|
|
9 |
|
|
19 |
|
|
|
| 9 |
35 |
| 57 |
60 |
|
|
31 |
|
|
11