Weider WESY81080 manual Trouble-shooting and Maintenance, Tightening the Cables

Page 19

Trouble-shooting and Maintenance

Inspect and tighten all parts each time you use the home gym system. Replace any worn parts immediately. The home gym system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.

Tightening the Cables

Woven cable, the type of cable used on the home gym system, can stretch slightly when it is first used. If there is slack in the Cables before resistance is felt, the Cables should be tightened.

To tighten the Cables, insert the Weight Pin (39, not shown) between the third and the fourth Weight, counting from the top. See ÒChanging the Weight SettingÓ on page 17 for instructions on moving the Weight Pin.

Loosen the 5/16Ó Plain Nut (32) holding the Eyebolt (44) to the Leg Lever (29). Tighten the Eyebolt a couple of turns until the Cables feel tighter. Tighten the Plain Nut to prevent the Eyebolt from turning.

Additional slack can be removed by moving the ÒVÓ-Pulley

(6)to one of the other holes in the bracket (P) on the Seat Frame (36). To do this, remove the 3/8Ó x 3 1/4Ó Bolt (69), Cable Trap (66), 3/8Ó Flat Washer (55) and 3/8Ó Nylon Locknut (63). Move the ÒVÓ-Pulley and re-attach it with the Bolt, Washer, Cable Trap and Locknut.

Note: If a Cable tends to slip off the Pulleys often, the Cable may have become twisted. Remove the Cable and re-install it.

If the Cables need to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this manual.

1

 

44

29

 

32

 

1

 

36

 

P

 

63

 

55

 

6

 

66

 

69

 

19

Image 19
Contents Model No. WESY81080 Serial No QUESTIONS?Limited Warranty Table of ContentsImportant Precautions Before You Begin Four Stages of the Assembly Process AssemblyDo not tighten the Nylon Locknuts yet Frame AssemblyDo not tighten the Locknuts yet Locate and open the parts bag labeled Òarm ASSEMBLY.Ó Arm AssemblyTighten all Nylon Locknuts used in steps 3 through Tap two 1Ó Retainers 4 and a 1Ó Round Cover Cap Nylon Jamnut. The Leg Lever should pivot freely Cable AssemblyMake sure the Cable Trap 66 is positioned as shown Page Page Locate and open the parts bag labeled Òseat ASSEMBLY.Ó Seat AssemblyMiscellaneous Assembly Cable ID Chart Long Cable Cable DiagramShort Cable Changing the Weight Setting AdjustmentWeight Resistance Chart Tightening the Cables Trouble-shooting and MaintenancePart Identification ChartÑWESY81080 Page Page Exploded DrawingÑModel No. WESY81080 Qty Description Part ListÑModel No. WESY81080Ordering Replacement Parts