Weider WESY5993.2 user manual Important Precautions

Page 3
12. Make sure the storage knob is in place and fully tightened each time the resistance sys- tem is used.
13. When adding resistance, both ends of the resistance bar must rest under the two “U”- channels. Add and remove resistance bars from the “U”-channels one resistance bar at a time.
14. Keep clear of the area around the “U”-chan- nels while the resistance system is in use. Do not add or remove resistance bars from the “U”-channels while the end of the long cable is pulled out.
15. Always adjust the resistance bar assembly to
the horizontal position and make sure the fulcrum knob is secure before using the resistance system.
16. Make sure the rings on the resistance bars are pushed against the tray before using the resistance system.
17. Always disconnect the lat bar from the short
cables when performing an exercise that does not require it.
18. The resistance system is designed to be used with the included resistance, and the resistance included with a MAX by WEIDER MAX PACK. Do not use the resistance sys- tem with any other type of resistance.
19. Make sure that the cables remain on the pul- leys at all times. If the cables bind as you are exercising, stop immediately and make sure that the cables are on the pulleys. Replace all cables at least every two years.
20. If you feel pain or dizziness while exercising, stop immediately and begin cooling down.

IMPORTANT PRECAUTIONS

WARNING: To reduce the risk of serious injury, read the following important precautions before using the resistance system.

1. Read all instructions in this manual and all warnings on the resistance system before using the resistance system. Use the resist- ance system only as described in this manual.

2. It is the responsibility of the owner to ensure that all users of the resistance system are adequately informed of all precautions.

3. The resistance system is intended for home use only. Do not use the resistance system in any commercial, rental, or institutional setting.

4. Keep the resistance system indoors, away from moisture and dust. Place the resistance system on a level surface, with a mat beneath it to protect the floor or carpet. Make sure that there is enough clearance around the resistance system to mount, dismount, and use the resistance system.

5. Inspect and properly tighten all parts regular- ly. Replace any worn parts immediately.

6. Keep children under 12 and pets away from the resistance system at all times.

7. Keep hands and feet away from moving parts.

8. Always wear athletic shoes for foot protec- tion while exercising.

9. The top frame is not designed to be used for pull-up exercises. Do not hang on the top frame.

10. The resistance system is designed to sup- port a maximum user weight of 300 pounds.

11. Pull on the low pulley cable only while sitting on the bench or standing on the base plate. Pull on the high pulley cables only while sit- ting on the bench, with the seat in one of the three positions closest to the upright base, or while standing on the base plate.

WARNING: Before beginning this or any exercise program, consult your physician. This is especially important for persons over the age of 35 or persons with pre-existing health problems. Read all instructions before using. ICON assumes no responsibility for personal injury or property damage sustained by or through the use of this product.

3

Image 3
Contents Model No. WESY5993.2 Serial No QUESTIONS?Table of Contents Important Precautions Before YOU Begin Assembled DimensionsMake Things Easier for Yourself AssemblyInsert a bolt into the top hole in the Foot Plate Yet Locknuts 69. Make sure the slot in the KnobIs aligned with the slot in the Seat Carriage Ends of the Cable onto the Hook See the inset drawing. Thread the HookMake sure that the Eyebolts 34 are oriented Do not overtighten the Locknut the Leg Lever Must be able to pivot easilyOn the Leg Developer Locate the Long Cable 80. Insert one end Swivel Arm. Make sure the Cable is on the indiEdge of the Pulley Guard is on the side shown Make sure the flat edge of the Pulley Guard is On the bottom Page Adjustments Adjusting the SeatAttaching the High Pulleys and LEG Lever Adjusting the Resistance Attaching the AccessoriesStoring the Resistance System Adjusting the BackrestMake sure the rings are pushed against the Tray Cable DiagramUsing the Removable Resistance Bars Adjusting the LEG DeveloperWorking OUT Exercise GuidelinesPersonalizing Your Exercise Program Warming UPMuscle Chart Cooling DownStaying Motivated Wednesday DateExercise Resistance Sets Reps Aerobic ExercisePart Identification Chart Nylon Locknut Qty Description Part LIST-Model No. WESY5993.2Exploded DRAWING-Model No. WESY5993.2 Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT