Weider WESY5993.2 user manual Locate the Long Cable 80. Insert one end

15. Slide the Leg Developer (19) into the Bench Rail		15
(5). Align the hole in the Leg Developer with a
hole in the Front Leg (6). Tighten the Bench Knob			7
(42) into the hole in the Leg Developer.				19
Connect the eyebolt on the Leg Lever Cable (32)
to the indicated side of the Leg Lever (7) with a		65
5/16” Nylon Locknut (65).
		Eyebolt
		5	32	42
		6
16. Locate the Long Cable (80). Insert one end of		16
the Cable through the welded tube on the indicat-
ed end of the Cross Tube (11) and then through a					80
Swivel Arm (22). If necessary, use the tip of a						71
screwdriver to pull the end of the Cable out of the				11107
Swivel Arm. Make sure the Cable is on the indi-
cated side of the welded rod in the Swivel Arm.							22
Insert the Swivel Arm (22) into the welded tube				28
on the Cross Tube (11). Secure the Swivel Arm							Rod
with a #8 x 3/8” Screw (107).						76
Wrap the Long Cable (80) around a 90mm Pulley
(28). Attach the Pulley inside of the Swivel Arm
(22) with a 3/8” x 1 1/2”	Button Bolt (71) and a
3/8” Nylon Locknut (76).		17
17. Wrap the Long Cable (80) around a 90mm Pulley				Flat
(28). Attach the Pulley and a Pulley Guard (29) to				Edge	29	76
the indicated 3/8” x 5 1/2” Carriage Bolt (73) with
a 3/8” Nylon Locknut (76). Make sure the flat							80
edge of the Pulley Guard is on the side shown.			73
						28
18. Attach a Pulley Housing (94) to the indicated “U”-		18
channel on the 10-pound Center Resistance Bar
(44) with a 3/8” x 4” Button Bolt (24), two Pivot
Bushings (74), and a 3/8” Nylon Locknut (76).			44
Wrap the Long Cable (80) around a 90mm Pulley
(28). Attach the Pulley inside of the Pulley			76
Housing (94) with a 3/8” x 1 1/2” Button Bolt (71)					“U”-Channel
and a 3/8” Nylon Locknut (76).			74
			71	94	76
			28
				74
			80	24
		10