Weider WESY5993.2 user manual Make sure that the Eyebolts 34 are oriented

9.	Press two 1 1/2” Round Inner Caps (38) into the	9	65		70
	ends of the Top Frame (10).					75
	Attach two Eyebolts (34) to the Top Frame (10)		59
	with two 5/16” Washers (59) and two 5/16” Nylon					93
	Locknuts (65). Do not overtighten the Locknuts;		38				10
	the Eyebolts must be able to rotate freely.							65
	Attach the Top Frame (10) to the Lat Tower (4)		34
	with two 3/8” x 3” Button Screws (70), two 3/8”							59
	Washers (75), and the Top Frame Cover (93).							38
	Make sure that the Eyebolts (34) are oriented		Side View
	as shown in the inset drawing. If they are not,	10					34		4
	turn the Top Frame around and reattach it.			4
10.	Attach the two 10-pound Short Caps (20) to the	34
		10
	10-pound Center Resistance Bar (44) with two
	M4 x 12mm Flat Head Screws (85).
	Using ten M4 x 12mm Flat Head Screws (85),
	attach the two 10-pound Caps (101) to the 10-
	pound Removable Resistance Bar (67), the two							96
	20-pound Caps (88) to the 20-pound Removable						95
	Resistance Bar (36), the four 80-pound Caps									79
	(100) to the two 80-pound Resistance Bars (95),					36			85
	and the two 40-pound Caps (79) to the 40-pound				67
	Resistance Bar (96).							85		100
					44	85	85
							101	88
			85			20
11.	Locate the Fulcrum (18) on the Lat Tower (4) (see
		11					86
	the inset drawing). Slide the Tray (35) onto the							Edges
	rods on the Fulcrum. Make sure the Tray is ori-					72
	ented as shown in the drawing.							up
	Set the Resistance Bars into the Tray (35) in the
	following order: the 10-pound Removable								96
	Resistance Bar (67), the 20-pound Removable
	Resistance Bar (36), an 80-pound Resistance Bar	Rings on
	(95), the 10-pound Center Resistance Bar (44), an
	80-pound Resistance Bar (95), and the 40-pound	this side						44
	Resistance Bar (96). Make sure the indicated				35					95
	rings are on the side shown and the arrows
	point toward the Tray.				18					95
	Attach the Cover Plate (72), with the edges up, to		4				Rods	67		36
	the Tray (35) with two 5/16” x 3/4” Button Screws		18
	(86).
		8