Weider WESY5993.2 See the inset drawing. Thread the Hook, Ends of the Cable onto the Hook

6. Pull the Seat Knob (45, not shown) out as far as	6						Third
it will go, and slide the Seat Carriage (12) onto
the Bench Rail (5). Engage the Seat Knob into				45			Hole
the third hole from the end of the Bench Rail.
See the inset drawing. Thread the Hook (104)								5
into the bottom of the Bench Rail (5). Do not			62
overtighten the Hook, or the Bench Rail will	99
be difficult to assemble in step 7.					62		12
Press the two Rail Inner Caps (99), with the wide	Wide			6		92
ends on the top or bottom (as indicated), into the	End						32
ends of the Bench Rail (5). Attach the Caps with
four #8 x 3/4” Screws (62).		76						99	Wide
Locate the Leg Lever Cable (32), which has three
			Eyebolt		81		62		End
ends connected in the middle with a bracket.
Route the end of the Cable with the eyebolt under							5		62
a “V”-pulley (92). Attach the “V”-pulley to the
Front Leg (6) with a 3/8” x 4 1/4” Bolt (81) and a									104
3/8” Nylon Locknut (76). Slide the other two
ends of the Cable onto the Hook (104).	7
7. Attach the Bench Rail (5) to the Upright (3) with a						30
3/8” x 5 1/2” Bolt (66), a 3/4” Spacer (17), a 7/8”
Spacer (106), and a 3/8” Nylon Locknut (76).
Fully tighten the Storage Knob (30) into the					76		3
Upright and the Bench Rail.				17
			5						66
						106
8. Attach the Lat Tower (4) to the Upright (3) with	8
four 3/8” x 1” Button Screws (87) and four 3/8”
Split Washers (103).							4
Attach the Name Plate (89) to the Lat Tower (4)
with two #8 x 3/4” Screws (62).
								87
			62 89	62			103	87
				3
	7