Weider WESY68633 user manual Serrated edge of the Flange Nuts are against Seat Carriage

7. Grease an M10 x 69mm Bolt (93). Orient the Leg	7
Lever (32) with the slot on the side shown. Attach		93
the Leg Lever to the Front Leg (31) with the Bolt	Grease
and an M10 Nylon Locknut (71). Do not over-
tighten the Locknut; the Leg Lever must be
able to pivot easily.	32	Slot		71
			31
8. Attach the Seat Knob (43) to the Seat Carriage	8
(48) with two M6 x 13mm Bolts (105) and two M6
Nylon Locknuts (69). Make sure that the slot in
the Knob is aligned with the slot in the Seat
Carriage, as shown.	41
Orient the Seat (41), the Seat Backing (42), and
the Seat Carriage (48) as shown. Attach the Seat
and the Seat Backing to the Seat Carriage with	42
four M6 x 16mm Screws (11).				Slots
	48
	11	69	105	43 105
9. Pull out the Seat Knob (43) as far as it will go, and		11
	9		48
set the Seat Carriage (48) on the Bench Rail (23).
Loosely attach two 8mm Metal Spacers (45), a	47			102
60mm Metal Spacer (44), and two Bearing
Wheels (46) to the center holes in the Seat	41			47
Carriage (48) with two M8 Flange Nuts (47) and			43
the M8 x 114mm Axle (102). Make sure that the
serrated edge of the Flange Nuts are against	23
the Seat Carriage.
While a second person presses down on the Seat
(41), hold the wheel assembly firmly against the
bottom of the Bench Rail (23) and properly tight-
en the M8 Flange Nuts (47). Make sure that
three threads are extending past the Nuts, and
that the wide sides of all six Bearing Wheels
(46) are pressed against the Bench Rail.
Engage the Seat Knob (43) into an adjustment		45	46 44		46
hole in the Bench Rail (23).						45
		Wide
	9	Side