Weider WESY38322 user manual

44.Wrap the VKR Low Cable (72) over a 3 1/2” Pulley

(78).Attach the Pulley and a Cable Trap (68) between the lower set of holes in the “U”-bracket

(64)with a 3/8” x 2” Bolt (100) and a 3/8” Nylon Locknut (87). Make sure that the Cable Trap is turned to hold the Cable in the groove of the Pulley.

45.Attach the end of the VKR Low Cable (72) inside of the Short Base (2) with a 5/16” x 2 1/2” Bolt (59), two 5/16” Washers (90), and a 5/16” Nylon Locknut (86).

46.Locate the Squat Cable (73), which is the only remaining cable. Attach the eyelet end of the Cable inside of the Long Base (120) with a 5/16” x 2 1/2” Bolt (59), two 5/16” Washers (90), and a 5/16” Nylon Locknut (86).

47.Wrap the Squat Cable (73) over a 3 1/2” Pulley

(78).Attach the Pulley, a Cable Trap (68), and two 3/4” Spacers (124) between the indicated brackets on the Squat Slider (38) with a 3/8” x 3 1/4” Bolt

(96)and a 3/8” Nylon Jamnut (113). Make sure that the Cable Trap is turned to hold the Cable in the groove of the Pulley.

18

44
100
68			64
			87
72
			78
45
72
86
90
2		90	59
46
			73
				86
			90
				120
90
59
47	78	68
73
			124	113
124				38
	96