ASSEMBLY
• To watch an assembly video, go to http://productvideo.co/ assembly/sears/weider or use your mobile phone or your smartphone to read the QR code at the right.
• Left parts are marked “L” or “Left” and right parts are marked “R” or “Right.”
• To identify small parts, see page 5.
• In addition to the included tool(s), assembly requires the following tool(s):
• Assembly requires two persons.
• Due to its weight and size, the weight bench should be assembled in the location where it will be used. Make sure that there is enough clear- ance to walk around the weight bench as you assemble it.
• Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you nish all assembly steps.
one adjustable wrench
one Phillips screwdriver
Assembly may be easier if you have a set of wrenches. To avoid damaging parts, do not use power tools.
1. Orient the Crossbar (2) as shown. | 1 |
|
|
| |
Attach the Crossbar (2) to one of the Uprights |
|
|
(3) with two M10 x 80mm Screws (27); do not |
|
|
tighten the Screws yet. |
|
|
Attach the Crossbar (2) to the other Upright | 3 |
|
(3) in the same way. |
|
|
| Warning |
|
| Decals | 3 |
|
| |
| 2 |
|
|
| 27 |
| 6 |
|