5.Insert the Seat Bracket (10) and the Backrest Bracket (7) into the two slots in the Frame (1) as shown.
Align the brackets on the Seat Frames (8, 9) and the brackets on the Backrest Frames (5, 6) with the welded tube on the Frame (1), as shown in the inset drawing.
Attach the Seat Frames (8, 9) and the Backrest Frames (5, 6) to the Frame (1) with an M12 x 132mm Bolt (25) and an M12 Locknut (26). Do not overtighten the Locknut; the Seat Frames and the Backrest Frames must be able to pivot.
6.Tighten the Curl Post Knob (14) into the Frame
(1) in the indicated location.
Next, tighten one of the Bracket Knobs (13) into the Frame (1) and into one of the adjustment holes in the Seat Bracket (10).
Tighten the other Bracket Knob (13) into the Frame (1) and into one of the adjustment holes in the Backrest Bracket (7).
Then, attach an M10 x 20mm Screw (29) and an M10 Locknut (30) to the lower end of the Backrest Bracket (7).
5 |
|
|
|
| 5 |
|
| 6 |
26 | 8 | 7 |
|
| 9 |
10 |
| 25 |
|
| |
|
| 1 |
6 |
|
|
|
13 |
|
| 7 |
13 |
|
|
|
14 | 10 | 29 | 30 |
|
| ||
|
|
| |
1 |
|
|
|
8