Electrolux 76639 manual Pay attention to the maxi

Operating Instructions

Problem	Possible Cause	Remedy
		Pay attention to the maxi-
Washing heavily	Probably too much washing	mum load quantity (see Pro-
		gram tables). In the case of
creased	put in the drum.
		easy-care fabrics, select the
		EASY IRON program.
	Drain hose is kinked.	Remove the kink.
The washing is not suf-		Contact your local Service
	Maximum pump head (dis-	Force Centre. For pumping
ficiently spun. Water is
	charge height 1m from the	heights over 1m a conver-
left in the drum.
	appliance's base) is exceeded.	sion kit is available as a spe-
The fault code E20
		cial accessory.
appears . The RINSE
display flashes.		Switch off the appliance and
	Drain pump is blocked.	pull out the mains plug.
		Clean the drain pump.
		Wait until the DOOR display
		lights up green.
		If it is still necessary to open
	The door is locked due to a	the door:
	high water level or a high	turn the program selector to
	temperature. (the DOOR dis-	OFF turn the program selec-
	play is off).	tor to PUMP OUT. Press the
		START/PAUSE button
The door cannot be		After the water has been
opened when the		pumped out, the door can be
appliance is switched		opened.
on.
		If water can be seen through
		the window in the door, first
	Power failure! (All displays	carry out emergency empty-
	have gone off.)	ing (see section “Carrying out
	For safety reasons the door	Emergency Emptying Opera-
	remains locked for 4 to 5	tion").
	minutes.	After approx. 4 to 5 minutes
		the door can be opened
		again by pulling the handle.
	Water tap is not fully	Open the water tap fully.
Remnants of detergent	opened.
are building up in the	The inlet hose filter in the	Close the water tap. Unscrew
detergent dispenser
		the inlet hose from the water
drawer.	coupling inlet hose at the
		tap and from the appliance.
	tap is blocked.
		Clean the filter.

32