Electrolux LAVAMAT 74700 manual

Problem	Possible cause	Remedy
E10 appears.	The tap is shut off.	Turn on the tap.
The END indicator is		Turn off the tap. Unscrew the
flashing once, and si-	The filter in the inlet hose	Turn off the tap. Unscrew the
flashing once, and si-	The filter in the inlet hose	hose, remove the filter and
multaneously an acous-	screw connection is blocked.	hose, remove the filter and
tic signal is sounding		clean it.
tic signal is sounding
once.	The tap is blocked by limes-	Check the tap and have it re-
(Problems with the wa-	The tap is blocked by limes-	Check the tap and have it re-
(Problems with the wa-	cale or faulty.	paired, if necessary.
ter inflow.)	cale or faulty.	paired, if necessary.
ter inflow.)
	The transit packaging has	Removing the transit pack-
The washing machine	not been removed.	aging.
The washing machine
vibrates when operating	The screw feet not correctly	Adjust the feet as described
or is not stable.		Adjust the feet as described
or is not stable.		in the installation and con-
	adjusted.	in the installation and con-
	adjusted.	nection instructions.
		nection instructions.
Washing has not been	Only a few large items of	Always load the drum as full
Washing has not been	Only a few large items of	as possible. Mix large and
spun.	washing in the drum.	as possible. Mix large and
spun.	washing in the drum.	small items.
		small items.
	The inlet hose screw con-	Tighten the inlet hose.
	nection is leaking.	Tighten the inlet hose.
	nection is leaking.
	The outlet hose is leaking.	Replace outlet hose.
Water is running out	The drain pump lid has not	Close the cover properly.
from under the washing	been closed properly.	Close the cover properly.
from under the washing	been closed properly.
machine.
machine.	Washing was caught in the	Load carefully next time you
	Washing was caught in the	Load carefully next time you
	door.	wash.
	The emergency drain hose is	Screw on the emergency
	leaking.	drain hose firmly.
The wash water is		Follow the manufacturer's
foaming a lot. At the	Probably too much deter-	Follow the manufacturer's
foaming a lot. At the	Probably too much deter-	instructions exactly when
end of the wash cycle	gent has been used.	instructions exactly when
end of the wash cycle	gent has been used.	measuring out detergent.
the spinning stops.		measuring out detergent.
the spinning stops.
	There is a kink in the outlet	Straighten the hose.
	hose.	Straighten the hose.
	hose.
E20 appears.	The maximum pump height	Please contact your local
The END indicator is	of 1m has been exceeded.	Service Force Centre
flashing twice, and si-		Switch off the appliance.
multaneously an acous-		Switch off the appliance.
tic signal is sounding		Disconnect the power plug.
twice.	The drain pipe is blocked.	Clean the drain pump. Re-
(Problems with the wa-		move foreign bodies from
ter outflow.)		the pump housing.
	For sink spigot connections:	Clean the spigot.
	The spigot is blocked.	Clean the spigot.
	The spigot is blocked.

Problem

E10 appears.

The tap is shut off.

Turn on the tap.

The END indicator is