Electrolux LAVAMAT 86810 manual Setup, Washing cycle complete/Removing the washing, Memory 1, 2

Page 21

Washing cycle complete/Removing the washing

At the end of the cycle a long acoustic signal sounds 3 times (when the SOUND setting is NORMAL or LOW) and the messages “Cycle ended” and “Door openable” appear alternately in the display.

1.Open the door and remove the washing.

2.Turn the programme knob to OFF.

3.Turn off the tap.

4.After the wash, pull out the detergent dispenser drawer slightly to al- low it to dry. Leave the door slightly open to air the inside of the wash- ing machine.

If RINSE HOLD or NIGHT CYCLE was selected:

After a Rinse Hold or when a programme with NIGHT CYCLE has ended, the START/PAUSE indicator flashes. “Cycle ended” and “Door locked” appear alternately in the display.

The water must first be drained off:

–Turn the programme knob to OFF, then to DRAIN and press the START/PAUSE key (the water is drained without spinning),

or

–or turn the programme knob to OFF and then to SPIN. Change the spin speed if necessary and press the START/PAUSE key (the water is drained and the washing spun).

Setup

The special functions that can be set under Setup remain permanently stored independent of each washing cycle – even after the appliance has been switched off or the mains plug has been removed from the socket.

Memory 1, 2, 3

Programme combinations can be stored at programme knob positions MEMORY 1, 2, 3 and can then be selected using the programme knob. To do this the desired programme combination is first put together and then stored.

21

Image 21

Contents Lavamat Dear Customer Following symbols are used in the textContents Safety information concerning installation Installation and connection instructionsPrior to using the appliance for the first time SafetyChild safety Follow the Installation and connection instructionsResulting overheating may constitute a fire hazard General safetyCycle end at What is shown in the displayEasy Iron Program overviewUse/Features Care Symbols1 N g u a g e Prior to using for the first timeR a c h e Programmende umPreparing and sorting washing Setting the timeCarrying out a wash programme prior to first use Preparing washingRunning a wash cycle Adding detergent/conditionerWashing powder/tablets for the main wash cycle If you are using liquid detergent Switching on the appliance/selecting a programChanging spin speed/selecting rinse hold Speed or Rinse Hold is displayedWith spin speed 0 the TEMP. RPM Options OK Time Max . load Opening the door/Loading the washingCurrent load display goes out if the door is closed Sensitive Setting optionsPrewashing SensitivePrewash, Sensitive, Stain, Night Cycle Delay Start Setting timesTime saving Time Saving Short or Very ShortStart in 4h Delay StartStart Starting a programmeProgramme progress WashingInterrupting a programme/Adding washing Interrupting a programmeWashing cycle complete/Removing the washing SetupMemory 1, 2 If Rinse Hold or Night Cycle was selectedSetting the Memory Memory Store programChanging the Memory U n d VolumeN s e + Extra RinseSet time LanguageClock Desired setting. With Contrast and brightnessEach press of the key or if Deactivating the child safety device Child safety deviceCleaning procedure Cleaning and maintenanceDetergent dispenser drawer Washing drumWhat to do if Clean the glass in the door and the rubber collar regularlyDoor and rubber collar Remedying small malfunctionsTap turned off Turn the tap on There are grey stains on the washing If the wash result is not satisfactoryFoam can still be seen following the final rinse There are white residues on the washingCarrying out an emergency drain When the water has all drained awayDrain pump Disposal Packaging materialOld appliance Consumption values Technical dataThis washing machine cannot be built-in Safety information concerning installationWhen using a sack trolley to transport the washing machine Installing the applianceTransporting the appliance Removing the transport lockWhere to install Remove both plastic caps sidewaysAppliance If the appliance is to stand on a base Making the appliance levelBrown Live Wire coloured green and yellow Electrical ConnectionPermanent Connection Permitted water pressure Connecting the appliance to the water supply35m long pressure hose is supplied with the appliance Water inletFrom your Service Force Centre Water DrainageFor drainage into an outlet Pumping heights of over 1 metre Great Britain Guarantee/Customer ServiceLU4 9QQ European GuaranteeMagyarország +36 Customer Care 0870 5 929For general enquiries concerning Major Appliances105 176 Subject to change without notice