JVC RX-6510VBK manual Specifications, Per channel, min. RMS, driven into 8 Ω, Harmonic distortion

Page 38

English

Specifications

Amplifier

Output Power

 

 

 

 

 

 

At Stereo operation:

 

 

 

 

 

Front channels:

100 W per channel, min. RMS, driven into 8 Ω,

 

 

40 Hz to 20 kHz with no more than 0.8% total

 

 

harmonic distortion.

 

 

At Surround operation:

 

 

 

 

 

Front channels:

100 W per channel, min. RMS, driven into 8 Ω at 1 kHz with no

 

 

more than 0.8% total harmonic distortion.

 

Center channel:

100 W, min. RMS, driven into 8 Ω at 1 kHz, with no more than

 

 

0.8% total harmonic distortion.

 

 

Rear channels

100 W per channel, min. RMS, driven into 8 Ω at 1 kHz, with no

 

 

more than 0.8% total harmonic distortion.

Audio

 

 

 

 

 

Audio Input Sensitivity/Impedance (1 kHz):

CD, TAPE/CDR, TV SOUND, VCR, DVD:

220 mV/47 kΩ

Audio Input (DIGITAL IN)* :

Coaxial: DIGITAL 1 (DVD):

 

0.5 V(p-p)/75 Ω

 

Optical: DIGITAL 2 (CD):

 

–21 dBm to –15 dBm (660 nm ±30 nm)

*Corresponding to Linear PCM, Dolby Digital, and DTS Digital Surround (with sampling frequency — 32 kHz, 44.1 kHz, 48 kHz).

Audio Output Level:

TAPE/CDR, VCR:

 

 

220 mV

 

Signal-to-Noise Ratio (’66 IHF/’78 IHF):

CD, TAPE/CDR, TV SOUND, VCR, DVD:

87 dB/67 dB

 

Frequency Response (8 Ω)

CD, TAPE/CDR, TV SOUND, VCR, DVD:

20 Hz to 20 kHz (±1 dB)

Bass boost:

+3 dB ±1.0 dB at 100 Hz

 

 

 

Tone Control:

Bass (100 Hz):

±10 dB

 

 

 

 

Treble (10 kHz):

±10 dB

 

 

 

Video

 

 

 

 

 

Video Input Sensitivity/Impedance:

 

 

 

 

 

Composite video:

VCR, DVD:

 

 

 

1 V(p-p)/75 Ω

S-video:

VCR, DVD:

 

(Y: luminance):

1 V(p-p)/75 Ω

 

 

 

(C: chrominance, burst):

0.286 V(p-p)/75 Ω

Video Output Level:

 

 

 

 

 

Composite video:

VCR, MONITOR OUT:

 

 

1 V(p-p)/75 Ω

S-video:

VCR, MONITOR OUT:

(Y: luminance):

1 V(p-p)/75 Ω

 

 

 

(C: chrominance, burst):

0.286 V(p-p)/75 Ω

Synchronization:

Negative

 

 

 

 

Signal-to-Noise Ratio:

45 dB

 

 

 

 

35

Page 37 Page 39
Image 38
Page 37 Page 39
Contents RX-6510VBK Mises en garde, précautions et indications diverses English Français Table of Contents Parts Identification Remote ControlEx. When you press CD button Front PanelChecking the Supplied Accessories Before InstallationConnecting the FM and AM Antennas Getting StartedConnecting the front speakers Connecting the SpeakersBasic connecting procedure AM Antenna ConnectionsAnalog connections Connecting Audio/Video ComponentsConnecting the rear and center speakers Audio component connectionsCD recorder To audio inputVideo component connections If your audio components have a Compu Link jackDVD player Digital connectionsTo S-video input To composite video input Digital TV DVD playerPlug the power cord into an AC outlet R6PSUM-3/AA15FSelecting the Source to Play Turning the Power On and Off StandbyBasic Operations Selecting the Front Speakers Adjusting the VolumeListening only with headphones Selecting different sources for picture and soundAdjusting the Subwoofer Output Level Attenuating the Input SignalAdjusting the Tone Muting the SoundSetting the Subwoofer Information Basic SettingsAdjusting the Front Speaker Output Balance Recording a SourceRear Delay appears on Display Setting the Speakers for the DSP ModesCenter Delay appears on Display To select the delay time of the rear speaker outputDrange Comp Dynamic Range Compression appears on Display Crossover FRQ Crossover Frequency appears on the displayTo select the low frequency effect attenuator level To select the appropriate item About the compression levelDigital Input Digital in Terminal Setting Selecting the Analog or Digital Input ModeChange the input mode Storing the Basic Settings AdjustmentsUsing the Sleep Timer Press ANALOG/DIGITAL toReceiving Radio Broadcasts Tuning in Stations ManuallyUsing Preset Tuning Selecting the FM Reception Mode Surround modes Using the DSP ModesWhat are the DSP Modes? Early reflections Behind Direct sounds Reproducing the Sound FieldDAP modes Possible × ImpossibleAvailable DSP Modes According to the Speaker Arrangement Adjusting the Surround Modes Press Effect to select an effect Press DSP Mode repeatedly untilAdjust the effect level Level you wantAdjust the rear speaker output levels Adjusting the DAP ModesDAP mode Live Club Dance CLUB, HALL, or Pavilion appears on DisplayActivating the DSP Modes To cancel the Dolby/DTS Surround modeTo cancel the DSP mode Press Surround ON/OFFPress the play 3 button on the CD player Compu Link Remote Control SystemRemote Control through the Remote Sensor on the Receiver Automatic Source SelectionTuner Operating JVC’s Audio/Video ComponentsOperating Audio Components Sound control section AmplifierCassette deck CD changer7/P REWStop Operating Video ComponentsPlay PauseRelease TV Power Press and hold TV PowerEnter manufacturer’s code using buttons Operating Other Manufacturers’ Video EquipmentRelease CATV/DBS Power If there are more than one code listed for your brand Release VCR PowerTry to operate your VCR by pressing VCR Power JVC Denon Panasonic Philips Pioneer Release Audio PowerPlay 04, 05Troubleshooting Problem Possible Cause SolutionHz to 20 kHz with no more than 0.8% total SpecificationsPer channel, min. RMS, driven into 8 Ω Harmonic distortionGeneral FM tuner IHFAM tuner EN, FR 0301NHMMDWJEIN

RX-6510VBK specifications

The JVC RX-6510VBK is a dynamic and robust A/V receiver that caters to both audiophiles and casual listeners alike. This versatile piece of equipment combines advanced technology with user-friendly features, making it an excellent choice for home theater setups and music enthusiasts.

One of the standout characteristics of the RX-6510VBK is its power output. It delivers 100 watts per channel across five channels, ensuring that movies and music come alive with impressive clarity and depth. The receiver supports a range of speaker configurations, allowing users to optimize their sound experience based on their available space and preferences. The flexibility of setup means that whether you are using a simple stereo speaker system or a full surround sound setup, the RX-6510VBK can accommodate and enhance the experience.

In terms of connectivity, the RX-6510VBK is equipped with multiple HDMI inputs, allowing users to connect various devices such as Blu-ray players, gaming consoles, and streaming devices effortlessly. The support for 4K video pass-through ensures that users can enjoy their media in stunning high definition, future-proofing their home entertainment systems. Additionally, the receiver includes optical and coaxial digital audio inputs, ensuring compatibility with a wide range of devices.

A notable technology incorporated within the RX-6510VBK is JVC’s digital sound processing, which enhances audio playback and ensures a clear, immersive sound experience. The built-in equalizer provides various settings to tailor the audio output based on listener preferences or room characteristics. This personalization allows for a sound profile that ideally suits the environment and enhances listener enjoyment.

Further enhancing its usability is the intuitive remote control that simplifies operation from across the room. The on-screen display provides quick access to settings and adjustments, making navigation straightforward and user-friendly.

With its range of features, solid power output, and impressive connectivity options, the JVC RX-6510VBK stands out as a reliable and high-quality choice for anyone looking to elevate their audio-visual experience. Whether it’s for movie nights or music enjoyment, this receiver delivers performance and flexibility that meets the demands of modern home entertainment systems.
Top Page Image Contents