JVC LVT1112-001A manual For TV and video format, For T-V Link

Getting started

For TV and video format

•When the TV is equipped with the multiple SCART terminals, refer to the TV manual to check the available video signals for each terminal, then connect SCART cable correctly.

•This receiver cannot convert the video signals (S-video or Composite). When the video signal of one video component is different from that of the other (for example, one is S-video, the other is Composite), you may not see the pictures appropriately. In this case, unify the video signals of all the video components into S-video or Composite, or you need to switch the video signal of TV each time you change the source.

For T-V LINK

•You can use the T-V LINK function if you connect a T-V LINK compatible TV and VR to this receiver with a fully wired SCART cables. For details on T-V LINK, refer also to the manuals supplied with the TV and the VR.

•Connect a SCART cable to EXT-2 terminal on your JVC’s T-V LINK compatible TV for the T-V LINK function.

•Some TV, VR, STB and DVD players support the data communication like T-V LINK. For complete details, refer also to the manuals supplied with these components.

SCART Terminal Specifications

		TV	VR	STB	DVD
AUDIO	L/R	◯	◯	◯	◯
IN	Composite	◯	◯	◯	◯
		−
VIDEO	S-video		◯	◯	◯
	RGB	−	◯	◯	◯
AUDIO	L/R	◯*1	◯*1
OUT	Composite	◯*1*2	◯*1*2
			−
VIDEO	S-video	◯*2
	RGB	◯*2	−
T-V LINK		◯*3	◯*3	◯*3	◯*3

*1 The signals input from a SCART terminal cannot be output through the same SCART terminal.

*2 The video format of the output video signals are consistent with that of the input video signals. For example, if S-video signals are input to this receiver, no signals other than S-video signals can be output from this receiver.

Refer to the manuals supplied with the video components to check the setting of the input/output video signals.

*3 The signals for the T-V LINK function are always going through the receiver.

9