Whirlpool W10150630A ReverseDoorSwingOptional, Reversible Large Side-Swing Door

Page 9

ReverseDoorSwing(Optional)

You can change your door swing from a right-side opening to a left-side opening, if desired.

Reversible Large Side-Swing Door

A

B

D

C

2.Open dryer door. Remove bottom screws from cabinet side of hinges (D). Loosen (do not remove) top screws from cabinet side of hinges.

3.Lift door until top screws in cabinet are in large part of hinge slot. Pull door forward off screws. Set door (handle side up) on top of dryer. Remove top screws from cabinet.

4.Remove screws attaching hinges to door.

5.Remove screws at top, bottom and side of door (4 screws). Holding door over towel on dryer, grasp sides of outer door and gently lift to separate it from inner door. Do not pry apart with putty knife. Do not pull on door seal or plastic door catches.

6.Be certain to keep cardboard spacer centered between doors. Reattach outer door panel to inner door panel so handle is on the side where hinges were just removed.

1.Place towel (A) on top of dryer to protect surface.

2.Open dryer door. Remove bottom screws from cabinet side of hinges (C). Loosen (do not remove) top screws from cabinet side of hinges.

3.Lift door until top screws in cabinet are in large part of hinge slot. Pull door forward off screws. Set door on top of dryer. Remove top screws from cabinet.

4.Use a small, flat-blade screwdriver to gently remove 4 hinge hole plugs (D) on left side of cabinet. Insert plugs into hinge holes on right-hand side of cabinet.

5.Insert screws into bottom holes on left side of cabinet. Tighten screws halfway. Position door so large end of door hinge slot is over screws. Slide door up so screws are in bottom of slots. Tighten screws. Insert and tighten top screws in hinges.

6.Close door and check that door strike aligns with door catch

(B). If needed, slide door catch left or right within slot to adjust alignment.

Reversible Super Wide Side-Swing Door

A

B

C

E

F

D

7.Attach door hinges to dryer door so that the larger hole is at the bottom of the hinge.

8.Remove door strike (E) from cabinet. Use a small, flat-blade screwdriver to gently remove 4 hinge hole plugs (F) on left side of cabinet. Insert plugs into hinge holes on right side of cabinet.

9.Insert screws into bottom holes on left side of cabinet. Tighten screws halfway. Position door so large end of door hinge slot is over screws. Slide door up so screws are in bottom of slots. Tighten screws. Insert and tighten top screws in hinges.

10.Remove door strike plug (B). Insert the door strike you removed in Step 8 into hole and secure with screw. Insert door strike plug into original door strike hole and secure with screw.

11.Close door and check that door strike aligns with door catch

(C). If it is needed, slide door catch left or right within slot to adjust alignment.

1.Place towel (A) on top of dryer to protect surface.

9

Image 9
Contents Dryer Safety Instructions D’INSTALLATION DE LA SécheuseTools andParts Installation InstructionsParts supplied Parts neededInstallation Clearances Dryer DimensionsLocationRequirements You will needMobile home installations require Mobile Home Additional Installation RequirementsElectrical Requirements Gas SupplyRequirementsGas supply pressure testing VentingRequirementsVent material PlanVentSystem Recommended exhaust installationsInstall LevelingLegs Install VentSystemVent system chart Special provisions for mobile home installationsConnectVent MakeGasConnectionLevelDryer For mobile home useReverseDoorSwingOptional Reversible Large Side-Swing DoorReversible Super Wide Side-Swing Door If the dryer will not start, check the following CompleteInstallationVotre sécurité et celle des autres est très importante Sécurité DE LA SécheuseInstructions D’INSTALLATION Exigencesd’installationOutillageetpièces nécessaires Dimensions de la sécheuse Espacements d’installation’installation dans une maison mobile exige Spécifications électriquesSpécifications delalimentation en gaz Canalisation d’arrivée de gazExigences concernant le raccordement au gaz Matériel pour lévacuation ExigencesconcernantlévacuationPlanificationdusystèmed’évacuation Installations d’évacuation recommandéesBrides de serrage ÉvacuationInstallationdespieds denivellement Installationdu systèmed’évacuationDéterminer litinéraire dacheminement du conduit Tableau des systèmes dévacuationRaccordementduconduitd’évacuation RaccordementaugazMiseàniveau dela sécheuse Pour utilisation dans une maison mobileInversiondusensdouverturedelaportefacultatif Grande porte réversible à pivotement latéralPorte réversible extra-large à pivotement latéral Acheverl’installation Si la sécheuse ne démarre pas, vérifier ce qui suitW10150630A SP PN W10150631A