Before you begin...
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING”. These words mean:
DANGER
You can be killed or seriously injured if you don’t immediately follow instructions.
WARNING
You can be killed or seriously injured if you don’t follow instructions.
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed.
Check that you have everything necessary for correct installation. Proper installation is your responsibility.
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as gasoline, away from dryer.
Place dryer at least 18 inches above the floor for a garage installation.
Failure to do so can result in death, explosion, or fire.
For proper drying performance:
The location must provide:
•Protection from weather and water: Do not store or use dryer where it will be exposed to water and weather.
•Room temperature above 45°F: If room temperature is below 45°F, automatic cycles may not shut off.
•Level floor: Maximum slope under entire dryer should not be more than 1 inch. If slope is greater than 1 inch, install Extended Dryer Feet Kit, Part No. 279810. Clothes may not tumble properly and automatic sensor cycles may not operate correctly if dryer is not level.
•Sturdy floor to support dryer weight of 175 pounds.
It is your responsibility to:
•Observe all governing codes and ordinances.
•Check code requirements: Some codes limit or do not permit installation of clothes dryers in garages, closets, mobile homes or sleeping quarters. Contact your local building inspector.
•Comply with the installation specifications and dimensions.
•Consider spacing requirements for companion appliances.
•Properly install dryer.
•Check that you have everything necessary for proper installation.
•Contact a qualified installer to insure that the electrical installation meets all national and local codes and ordinances.
Tools needed for installation
•level
•gloves
•adjustable wrench that opens to 1" or 1"
•
•#2 Phillips screwdriver
•safety glasses
•tin snipes (new vent installation)
•caulking gun and compound
•wire strippers (direct wire installation)
Parts supplied for installation
Remove parts package from dryer drum. Check that all parts were included.
4 leveling legs
2