Four-wire connection...
POWER SUPPLY CORD
spade
terminals with upturned ends
NEUTRAL | 3/4" | NEUTRAL (white) |
strain relief |
| |
|
|
4. Remove center terminal block screw.
6. Connect ground wire (green) of power supply cord to external ground conductor screw. Tighten screw.
external ground connection
5. Remove appliance ground wire (green with yellow stripes) from external ground connector screw. Fasten under center,
ground prong | ground wire | |
(green) | ||
| ||
| ring terminals |
8. Connect the other wires to outer terminal block screws. Tighten screws.
9. Tighten strain relief screws.
10. Insert tab of terminal block cover into slot of the dryer rear panel. Secure cover with
7. Connect neutral wire (white or center) of power supply cord under center screw of the terminal block. Tighten screw.
DIRECT WIRE
Preparing the wire:
4. Remove center terminal block screw.
6. Connect the ground wire (bare) of the power supply cable to the external
5. Remove appliance ground wire (green with yellow stripes) from external ground connector screw. Fasten under center,
3/4" U.L.- listed strain relief
to |
disconnect |
box |
1" of wires stripped of insulation
NEUTRAL wire (white or center)
ground conductor screw. Tighten screw.
bare ground wire
5"
8. Place the hooked ends of the other power supply cable wires under the outer terminal block screws (hook facing right).
Squeeze hooked ends together. Tighten screws.
9. Tighten strain relief screws.
7. Place the hooked end of the neutral wire (white or center) of power supply cable under the center screw of terminal block (hook facing right).
Squeeze hook end together. Tighten screw.
Direct wire cable must have |
|
|
|
|
four feet of extra length so |
|
|
|
|
dryer can be moved if needed. |
|
|
| Shape |
Strip 5 inches of outer covering |
|
|
| |
|
|
| ends of | |
from end of cable. Leave bare |
|
|
| wires |
|
|
| ||
ground wire at 5 inches. Cut |
|
|
| into a |
|
|
| hook. | |
wires. Strip insulation back |
|
|
|
|
1 inch. |
|
|
|
|
|
|
|
|
|
10. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with
9