Plumbing
Connect the water supply hose (the hose marked blue) to the cold water valve.
Turn on the valve and check for leaks. The water pressure must be within
(10 bar), a pressure reducer must be installed. If the water pressure is below 15 psi (1 bar), insufficient water may be available for a complete fill.
The water supply hose is equipped with a filter; please do not remove this filter.
Connection to the drain sys- tem.
The 5 ft. (1.5m) drain hose may be con- nected as follows:
1.Directly into a sink: hook the hose over the edge of the sink and secure it firmly (e.g. by tying the hose to the water faucet).
2.To a stand pipe: place the drain hose
into a 1 1/2“ (38 mm) stand pipe and firmly secure it.
3.To a floor drain: The machine is equipped with an
–The machine drains using a pump with a maximum delivery height of 4 ft. (1.2 m).
–Make sure there are no kinks in the drain hose.
–If desired, the drain hose may be ex- tended to 15 ft. (4.5 m) maximum.
33