Installation
Shortening the door panel
The door panel can be shortended to match the height with the adjacent cabinetry.
Installation |
^ Open the door. |
The measure X equals the space from the bottom of the washer door to the bottom of the adjacent cabinet.
Cut the bottom of the door panel with a jigsaw according to X.
Cut the side decor bars with a hacksaw.
^To remove the door panel unscrew the 10 screws (arrows) from the door sheet panel.
^Remove the three decor bars from the door panel by unscrewing the screws.
^Cut the bottom of the door panel and the two side decor bars by X.
^Drill four holes into the door panel to fix the lower decor bar.
^Install the decor bars and the door panel.
To install a decor panel, check if it need to shortend too.
44