Washer care
Cleaning the water inlet filters
The waher has two water inlet filters to protect each inlet valve.
These filters should be checked and cleaned if necessry every 6 months. This may have to be done more frequently with some water supplies.
^ Turn off the water valve.
^ Unscrew the inlet hose from the valve by turning he connector counterclockwise using a wrench if necessary.
^ Remove the rubber seal 1 from the connector.
^ Using needle nose pliers, grasp the plastic filter, 2, and pull it out of the hose connector.
^ Clean the filter under running water and carefully remove any large particles.
^ Replace the filter and seal and reconnect the hose.
Slowly turn on the valve and check for leaks. If water leaks, tighten the bolt.
Both filters have to be put back in place after cleaning.
25