Miele W 1119 operating instructions Plumbing, Optional accessory hose extension

Page 50

Plumbing

The washing machine can be connected to a potable water supply. A non-return valve is not required unless required by building code.

The washing machine has 1/2" pressure hoses with 3/4" female hose thread connections. If there is no water hookup, contact a plumber to install a connection. Make sure that the sealing ring is seated properly on the hose connector.

Replace the hose with a genuine Miele hose only, or with a hose able to withstand up to 145 psi (10 bar) pressure. The water valve connector must also be able to withstand 145 psi (10 bar).

,The bolted connection is pressurized by water pressure. Open the water valve slowly to check for leaks. Adjust the rubber seal and the bolted connection if necessary.

To protect the inlet valve the two filters - one at the pressure hose / valve connection and one at the the inlet connection to the solenoid valve- must not be removed.

Optional accessory hose extension

Hose extensions with a length of

8’ 2 7/16" to 13’ 1 1/2" (2.5 to 4 m) are available from your Miele dealer or

Miele’s Technical Service Department.

46

Image 50
Contents Operating instructions Contents Contents Important Safety Instructions Guide to the washer Control panelBefore using for the first time General tips Using the washerPrepare and sort the laundry Load the laundry Select a program Close the drum doorProgram guide Silk Temperatures Fabric Spin Laundry Care Speed Symbol WoolensCold Med HandwashSelect wash options if needed Select the temperature and spin speed No spin Special spin optionsHold Too much detergent may cause Add detergentToo little detergent may cause Heavy soiling DetergentNormal soiling Water hardness Water softenerFabric softener Starch Do not exceed the maximum level markStart the program Select Delay Start if neededCancelling Delay Start Activate the program lock if necessaryRemove the laundry Interrupting a program Cancelling a programMaking changes to the program Adding/removing laundry during a wash program Drum door cannot be opened ifElectronic program lock Child Safety LockLocking the washer Clean the siphon tube Cleaning the washerCleaning the detergent drawer Washer careCleaning the water inlet filters Remove the tool Clean the drain pumpRemove and clean the lint trap Quick Guide Remove this guide for easy referenceLoad the laundry Quick GuideSort the laundry Select a programAdd detergent Select the temperature and spin speedSelect Delay Start if needed Start the programNormal Options Frequently asked questions Wash program cannot be startedProgram was interrupted and a fault message appears General issues with the washer Poor wash results Door will not open when the Door button is pressed Draining the wash water Door hinges on the left side Open the drum doorDoor hinges on the right side Warranty terms Technical ServicePC Update Optional accessoriesInstallation Instructions Disposal of an appliance Help protect our environmentDisposal of the packing material Installation Front viewBack view Remove the shipping struts Installation siteInstallation Do not lift the washer by the drum doorPull out the shipping strut Installing the shipping struts Adjust the four leveling feet Level the washerInstalling the decor panel Open the door InstallationShortening the door panel Washer stand with drawer Installation beneath a counterReinstallation of the machine lid Optional accessory hose extension PlumbingWater connection Tips for a hot water connectionDrainage Electrical connection Grounding InstructionsPage Page Alterations rights reserved