Miele W 1119 operating instructions Program was interrupted and a fault message appears

Page 32

Frequently asked questions

The program was interrupted and a fault message appears.

Issue

Possible cause

Solution*

The buzzer sounds, and

The drain is blocked.

Clean the drain pump and

the "Drain" indicator

 

lint trap. See "Washer care -

flashes.

 

Cleaning the drain pump

"- - -". appears in the

 

and lint trap".

display.

The drain hose is too

The maximum drain pump

 

high.

height should not exceed

 

 

4ft. (1.2 m).

The buzzer sounds, and

The water intake is

Check to determine if:

the "Intake" indicator

blocked.

– the water valve is open.

flashes.

 

– the inlet hose is kinked.

"- - -". appears in the

 

The inlet hose filter is

Clean the filter under

display.

dirty.

running water and carefully

 

 

 

remove any large particles.

The buzzer sounds, and

There is a fault.

Call the Miele Service

the "Intake" and "Drain"

 

Department.

indicators flash.

 

 

"- - -". appears in the

 

 

display.

 

 

The buzzer sounds and

There is a fault.

Restart the program.

the "Soak" and "Rinse"

 

If the fault message appears

indicators flash. "- - -".

 

again, call Miele’s Technical

appears in the display.

 

Service Department.

*To turn off the fault message: Turn off the washer using the "On/Off" button.

28

Image 32
Contents Operating instructions Contents Contents Important Safety Instructions Guide to the washer Control panelBefore using for the first time General tips Using the washerPrepare and sort the laundry Load the laundry Select a program Close the drum doorProgram guide Temperatures Fabric Spin Laundry Care Speed Symbol Woolens Cold MedSilk HandwashSelect wash options if needed Select the temperature and spin speed No spin Special spin optionsHold Too much detergent may cause Add detergentToo little detergent may cause Heavy soiling DetergentNormal soiling Water hardness Water softenerFabric softener Starch Do not exceed the maximum level markSelect Delay Start if needed Cancelling Delay StartStart the program Activate the program lock if necessaryRemove the laundry Interrupting a program Cancelling a programMaking changes to the program Adding/removing laundry during a wash program Drum door cannot be opened ifElectronic program lock Child Safety LockLocking the washer Cleaning the washer Cleaning the detergent drawerClean the siphon tube Washer careCleaning the water inlet filters Remove the tool Clean the drain pumpRemove and clean the lint trap Quick Guide Remove this guide for easy referenceQuick Guide Sort the laundryLoad the laundry Select a programSelect the temperature and spin speed Select Delay Start if neededAdd detergent Start the programNormal Options Frequently asked questions Wash program cannot be startedProgram was interrupted and a fault message appears General issues with the washer Poor wash results Door will not open when the Door button is pressed Draining the wash water Door hinges on the left side Open the drum doorDoor hinges on the right side Technical Service PC UpdateWarranty terms Optional accessoriesInstallation Instructions Disposal of an appliance Help protect our environmentDisposal of the packing material Installation Front viewBack view Installation site InstallationRemove the shipping struts Do not lift the washer by the drum doorPull out the shipping strut Installing the shipping struts Adjust the four leveling feet Level the washerInstalling the decor panel Open the door InstallationShortening the door panel Washer stand with drawer Installation beneath a counterReinstallation of the machine lid Optional accessory hose extension PlumbingWater connection Tips for a hot water connectionDrainage Electrical connection Grounding InstructionsPage Page Alterations rights reserved