JVC THD60 manual Operating external components, Setting the manufacturer’s code

Operating external components

Set the remote control mode before operation.

For TV

For DBS tuner or CATV converter

For VCR

Preparation

Make the audio input setting before

operation. ( 14)

Setting the manufacturer’s code

Before operating external components from the remote control, set the manufacturer’s code.

1Set the remote control mode (see above).

2Press and hold for the target component until the setting is finished.

For TV	For DBS tuner or	For VCR
	CATV converter
«Hold	«Hold

3

4 Enter the manufacturer’s code.

See “Manufacturer’s code list” for the

manufacturer’s code. ( 30)

5 Release .

If there is more than one code listed

for the corresponding brand, try each one until you enter the correct one.

Set the codes after replacing batteries of the remote control.

Operating external components

Set the remote control mode before operating each external component (see the left column).

Operating the TV

	TV	Turns the power on and off
TV VOL +/–		Adjusts the volume
TV/VIDEO		Selects the input mode (either
		TV or VIDEO)
CH +/–		Changes the channels
1-10, 0, h10 (100+)		Selects the channels
TV RETURN		Alternates between the
		previously selected channel
		and the current channel

Operating the DBS tuner or CATV converter

	VCR/DBS	Turns the power on and off
CH +/–		Changes the channels
1-10, 0, h10 (100+)		Selects the channels

Operating the VCR

	VCR/DBS	Turns the power on and off
3 (play button)		Starts playback

7Stops playback

8Pauses playback

yFast-forwards the tape

1Rewinds the tape

REC	Press this button together with 3
	(play button) to start recording or
	together with 8 to enter recording-
	pause.
CH +/–	Changes the TV channels
0 - 9	Selects the TV channels

29