AS202Pub1000003006 5/18/06 3:34 PM Page 6
E
SURGE OF STEAM
6.Turn the
•The
•It then glows on and off during ironing. This is normal.
7.When finished ironing, turn the
setting, move the dry/steam selector to 
and unplug the iron.
The
DRY IRONING
1.Make sure selector is set to 
. You may want to empty the water (see “Emptying Water Tank 1 After Ironing - Optional”).
2.Turn the
Read garment’s label to help you determine fabric type.
• The |
Use to remove stubborn creases.
•Horizontal
1.With Tank 1 filled with water to the MAX mark, turn the
2.To remove tough wrinkles, pump the 
button at
• It then glows on and off during ironing. |
3.When finished ironing, unplug the iron and place it on its heel rest.
4.Move the dry/steam selector to 
.
3-WAY AUTOMATIC SHUTOFF
The automatic shutoff feature in your iron works as follows:
• Once the iron reaches appropriate temperature, it will turn off |
• | Vertical |
| F |
Use for removing wrinkles from hanging clothes and drapes.
1.Hang the garment to be steamed on a clothes hanger (curtains or drapes can be steamed once they are hung).
2. Move the selector to | . |
3.Hold the iron close to, but not touching, the fabric.
4.Pull the fabric tight in your free hand and pump the button as you move the iron over the fabric (F).
30 seconds
K8 minutes
after 30 seconds of inactivity if left on its soleplate or tipped over |
on its side. If left vertically on its heel rest, it will shut off after |
8 minutes (K). |
• As soon as you pick up the iron, it will start heating again. |
Note: Wait for iron to reheat completely before resuming |
operation. |
EMPTYING TANK 1 AFTER IRONING (OPTIONAL)
Note: It is not necessary to empty the water after each use.
IRONING WITH SPRAY (TANK 2)
Using Downy Wrinkle Releaser® Liquid
1. Grasp Tank 2 fill cap, twist and pull off. Be careful not to pull it too hard (G).
L
1.Turn the
2.Unplug the iron and let it cool.
3.Open the
4.Empty the water by holding the iron over a sink with the tip pointing down. Water will empty out of
G
2. Pour Downy Wrinkle Releaser® liquid into opening to fill tank (H).
3. Replace cap and twist to close.
4. Press 
button to apply to fabric as you iron.
5. If spray is weak, pump the button a few times.
H
Using Water Only
Important: For best results, do not mix tap water with Downy
Wrinkle Releaser® liquid.
1. Repeat step 1 above.
| 2. | Using a clean cup, fill Tank 2 with water (J). |
J | 3. | Replace cap and twist to close. |
|
|
4.Press 
button to spray water as you iron.
5.If spray is weak, pump the button a few times.
Care and Cleaning
This product contains no user serviceable parts. Refer service to qualified service personnel.
CLEANING OUTSIDE SURFACES
1.Make sure iron is unplugged and has cooled completely.
2.Wipe the soleplate and outer surfaces with a soft cloth dampened with water and a mild household detergent. Never use abrasives,
3.After cleaning, plug in the iron.
4.Steam iron over an old cloth to remove any residue from the steam vents.
AUTO CLEANING
To keep the steam vents free of any buildup, about once a month follow these instructions.
1.Fill Tank 1 with water well below the MAX line.
2.Plug in the iron.
3.Turn the
4.Turn
5 | 6 |