Installation
Connection
andTransportation
Safety information
RISK OF INJURY!
To drain the pump refer to page31.
To drain the water hose(s) refer to page32.
Take care not to damage the washing machine. Donot hold onto protruding parts (e.g.loading door) when lifting.
In addition to the safety information listed here, t localwater and electricity supplier may have speci requirements.
In case of doubt, have the appliance connected an authorized technician.
The washing machine is heavy. Lift with caution.Factory$supplied equipment
CAUTION | There is a packet of accessory parts supplied | |
withyour washer. Check to make sure that all th | ||
|
Frozen hoses can tear/burst. Do not install | the accessory parts supplied for your model are there | |
washing machine outdoors or in an area | If any | parts are missing contact your dealer imm |
exposed to frost. | diately. |
|
| Inside | the drum: |
| ||
Be sure to observe all listed warnings and cautions. |
| |
These installation instructions are intended for use by qualified installers. In addition to these instructions the washer shall be installed:
-In the United States, in accordance with the National Electric Code, ANSI/NFPA70~ latest edition/State and Municipal codes and/or local codes.
-In Canada, in accordance with the Canadian Electric Code C22.1~ latest edition/State and Municipal codes and/or local codes.
If the washing machine is located in a room which will be exposed to temperatures below the freezing point, or if it is located in a cabin that is being shut
- Water supply hoses (cold and hot water).
down for the winter, any residual water in the pump or water inlet hose(s) must be drained.
39