Bosch Appliances WFR 2460 Before Using For, Using For the First Time, Selecting Language

						i	The	individual program steps are indicated in
							the	display field.
Before			Using	For	theWhen •Remove				laundry￿ is displayed:
First		Time				￿	Turn	the program		selectorOffto.
The washing machine must have been					installed	Selecting			the	language
and	connected		properly (refer	to page	39).	i	The	program	selector must not		be Offset. to
Before beginning to use your				washing	machine	for
the	first	time:				i	The	language must be selected			before
￿	Make	sure	the voltage the	washing	machine		a￿program is		started.
						￿
	is￿to operate on is the same as shown on					the	Simultaneously press theMenu andSelect
	rating	plate.					buttons and hold down (￿￿seconds) until the
￿	Check to make sure that			the water valves			current setting is			displayed.
						to the

washing machine are open.

Using For the First

Time

Your appliance was tested before leaving the factory. To remove any water left over from testing procedures, the first washing cycle should be carried out without laundry in the machine.

￿Do not load any laundry.

￿Turn on water tap.

￿Press theSelect button until the required language - e.English. - is displayed.

￿

￿	Confirm the language selection by pressing the
Pull out the detergent dispenser up to the final
stop.	Menu button.

￿

￿

i

Pour approx. 1 liter/1 quart of water			into	i
chamber￿II of the detergent dispenser.
Fill the measuring cup with detergent			half	and
pour into chamberII.
Do	not	use any special detergents for	delicates
or	wool	(excessive foam).

The selected setting is retained after the wash cycle.

￿Close the detergent dispenser.

￿Close the loading door.

￿Set the program selectorCotton Power

temp. boost.

The Start/Pause indicator light flashes (red).

￿Press theStart/Pause button. The program starts.

The indicator light is on (red).

8