Bosch Appliances WFR 2460, WFR 2450 manual Hos An abl, Watr onntion

Hos￿	an￿ ￿abl￿	l￿ngths
L￿ft!han￿	￿onn￿￿tion
	a￿￿￿￿x.	39"
	(100 cm)
	a￿￿￿￿x. 56½"(145	cm)
cm)
(100
39"
max.	a￿￿￿￿x. 35" (90 cm)

Right!han￿ ￿onn￿￿tion

a￿￿￿￿x.	56½"
(145	cm)
a￿￿￿￿x. 39" (100 cm)
		cm)
		(100
		39"
a￿￿￿￿x. 48¾" (135 cm)		max.

Oth￿r hos￿s

￿vailable at specialty dealers:

-￿xtended supply hose (approx. 2.2 m // ￿6.6￿in).

Wat￿r ￿onn￿￿tion

Wat￿r supply

CAUTION

The washing machine must only be operated with cold￿and hot (max.￿140￿°￿ // 60￿°￿) tap water. ￿o not connect the appliance to the mix tap of an unpressurized hot8water boiler.

If	in any doubt,	have the water connection install
by	an authorized	technician.

The water supply hoses must not be:

-￿ent or squashed.

-Modified or cut (stability can no longer be gu anteed).

Plastic threads must only be tightened by hand. ￿o￿not remove the strainers from the water suppl hoses.

Observe the water pressure in the supply networ

-The water pressure should be between 14.5

145	p.s.i. (1 to	10￿bars) (when the tap is t
on,	at least 2.2 U. S. gallons (￿ liters) of wa
are	discharged	per minute).

-￿ pressure reducing valve must be installed if the maximum water pressure is￿exceeded.

CAUTION

To prevent against water damage, the hot and cold water valves should be accessible when th washer is in place and shouldalways be turned

off when the washer is not in use.

When the washer is being installed in a new
building, or a building	in which		the plumbing		sy
tem was installed or upgraded recently,				the lines
must be flushed prior	to installing the			washer.
This must be done to	clear	the	lines	of any	s
dirt or residue that may still		be	in the	lines.

44