AEG W 730 manual Wash Cycle Completed/Removing Washing, If q Soaking has been selected

Operating Instructions

Wash Cycle Completed/Removing Washing

A wash programme normally ends with the final spin.

If q (SOAKING) has been selected:

0Release q(SOAKING) button. Main wash for t(COTTONS/LINEN) or }(EASY-CARES) will run.

If o (RINSE HOLD) has been selected:

The water must first be pumped out or the washing must still be spun.

0Either release the o(RINSE HOLD) button

(water is pumped out and the washing spun according to the pro- gramme that has been run; the spin speed can still be changed even during the spin),

or

turn the programme knob clockwise to v15 (PUMP OUT) (water is pumped out without spinning),

or

turn the programme knob clockwise to Position 5 or 10 (SPIN) (the wa- ter is pumped out and the washing spun at the set speed; the spin speed can still be changed even during the spin).

Once the programme is completed:

3	For safety reasons, the door remains locked for 1-2 minutes after the
	end of the programme.

1.Open the door.

2.Remove the washing.

3.Press the M (ON/OFF) button. The power indicator light will go out. The washing machine is switched off.

4.Close the water valve.

5.Pull the washing powder drawer out slightly to allow it to dry. Leave the door just slightly ajar so that the washing machine can air.

Important! If the washing machine is not used for a long time: Close the water tap and disconnect the washing machine from the electricity mains.

23