AEG W 730 manual Drawer æfor care

		Operating Instructions
Problem	Possible Cause	Remedy
Softener has not been	The softener insert has not
flushed into machine;		Wash the washing powder
	been correctly positioned in-
drawer æfor care		drawer and position the sof-
agent is filled with wa-	side the care agent compart-	tener insert firmly.
	ment or is blocked.
ter.
Washing is heavily	Probably too much washing	Follow instructions for the
		maximum filling quantity
creased.	was packed into the drum.
		(see Programme Tables).
	The drain hose is bent.	Remove the bend.
	Maximum pump head (outlet	Contact customer service; a
		retrofit kit is available as a
Washing has not been	head 1m from unit's floor	special accessory for pump
	surface) exceeded.
		heads over 1m.
spun properly. Residual
water is still visible in		Switch off the unit and pull
the drum.
	Drain pump is blocked.	out the mains plug. Clean
		the drain pump.
	Where a siphon is connected:	Clean the siphon.
	siphon is blocked.
	Water valve is not fully	Open the water valve fully.
	opened.
Detergent deposits
	Filter in the screw connec-	Close the water valve. Un-
form in the washing
powder drawer.	tion of the inlet hose on the	screw the inlet hose from the
	water valve or on the unit is	water tap and from the unit.
	blocked.	Clean the filter.
The rinsing water is	The cause is probably a	No negative influence on the
	washing powder/liquid with	rinse results; perhaps use liq-
murky.
	a high silicate content.	uid washing agent.
Door cannot be	Door is locked for safety rea-	Wait for 1 or 2 minutes after
opened.	sons.	the end of the programme.

31