AEG 76730 manual Water tap is closed Open the water tap No water runs

		Operating Instructions
Problem	Possible Cause	Remedy
	Water tap is closed.	Open the water tap.
No water runs in.		Close the water tap. Unscrew
	Filter in screw connection of	the hose from the water tap,
Fault code E10 ap-
	the intake hose is blocked.	remove the filter and clean it
pears. The indicator
		under running water.
RINSE+ flashes.
	Water tap is blocked with	Check water tap and have it
	limescale or is faulty.	repaired if necessary.
	The transport packaging has	Remove transport packaging
		according to the installation
	not been removed.
		and connection instructions.
	The height-adjustable screw	Adjust in accordance with
		the installation and connec-
	feet are not correctly set.
		tion instructions.
The washing machine	There is not much washing in	This does not impair the op-
vibrates during opera-
tion or it is on an une-	the drum (e.g. only one	eration of the machine.
	dressing gown).
ven surface.
	The water could not be com-	Check the laying of the
		drainage hose and eliminate
	pletely pumped off before	the bend if necessary, or
	spinning because the drain-
		clean the solution pump and,
	age hose is bent
		if required, remove foreign
	or
		bodies from the pump hous-
	the solution pump is blocked.
		ing.
The washing solution	Too much detergent was	Meter the detergent exactly
of the main wash		in accordance with the
	probably used.
froths up a lot.		manufacturer's information.

33