AEG 76730 manual Head 1m from units floor

		Operating Instructions
Problem	Possible Cause	Remedy
	Drainage hose bent.	Remove the bend.
		Consult Customer Service.
Washing not well spun.	Maximum pump head (outlet	They can supply a retrofit kit
	head 1m from unit's floor	as a special accessory for de-
Residual water still vis-	surface) exceeded.	livery heads of more than
ible in the drum.		1m.
Fault code E20 ap-
		Switch off the unit and pull
pears. The indicator
	Solution pump blocked.	out the mains plug. Clean
RINSE flashes.
		the solution pump.
	If a siphon is connected: Si-	Clean the siphon.
	phon blocked.
		Wait until the display DOOR
		lights up green.
		Should it nevertheless be
	The main door is locked be-	necessary to open the main
		door:
	cause of a high water level or
		Turn the programme knob to
	a high temperature. The dis-	OFF; turn the programme
	play DOOR is not lit.	knob to PUMP OUT. Press
		button START/PAUSE. The
The main door cannot		main door can be opened af-
be opened while the		ter the water has been
appliance is turned on.		pumped out.
		If water can be seen through
		the window in the door, first
	Power failure!	carry out emergency empty-
	(All displays have gone off.)	ing (see section “Carrying out
	For safety reasons the door	Emergency Emptying Opera-
	remains locked for 4 to	tion").
	5 minutes.	After approx. 4 to 5 minutes
		the door can be opened
		again by pulling the handle.
Washing detergent	Water tap not fully opened.	Open the water tap fully.
	Filter in the screw connec-	Close the water tap. Unscrew
residues form in the
washing detergent	tion of the intake hose on	the intake hose from the wa-
drawer.	the water tap or on the unit	ter tap and from the unit.
	is blocked.	Clean the filter.

35