AEG 72640 manual Intake hose blocked

Operating Instructions

Problem	Possible Cause	Remedy
	Water valve closed.	Open the water valve.
Water is not running.		Close the water valve. Un-
	Filter in screw connection of	screw the hose from the tap,
The fault code E10 ap-
	the intake hose blocked.	remove the sieve and clean
pears. The display		under running water
+Á(RINSE+) flashes.
	Water tap is blocked with	Check water tap and have it
	limescale or is faulty.	repaired if necessary.
	The transport packaging has	Remove transport packaging
		according to the installation
	not been removed.
		and connection instructions.
	The height-adjustable screw	Adjust the feet according to
		the installation and connec-
	feet are not correctly set.
		tion instructions.
The washing machine	There is not much washing in	This does not impair the op-
vibrates during opera-
tion or it is on an une-	the drum (e.g. only one	eration of the machine.
	dressing gown).
ven surface.
	The water could not be com-	Check the laying of the
		drainage hose and eliminate
	pletely pumped off before	the bend if necessary, or
	spinning because
		clean the solution pump and,
	The drainage hose is bent or
		if required, remove foreign
	The solution pump is
		bodies from the pump hous-
	blokked.
		ing.
The washing solution	Too much detergent was	Meter the detergent exactly
of the main wash		in accordance with the man-
	probably used
froths up a lot.		ufacturer's information.

32