AEG 72640 manual Drainage hose bent Remove the bend

Page 34

Operating Instructions

Problem

Possible Cause

Remedy

 

Drainage hose bent.

Remove the bend.

 

 

Contact your customer serv-

Washing not well spun.

Maximum pump head (dis-

ice. For pumping heights

charge height 1 m from the

over lm he can offer you a

Residual water still vis-

unit's floor) is exceeded.

conversion kit as a special

ible in the drum.

 

accessory.

The fault code E20 ap-

 

Switch off the unit and pull

pears. The Á(RINSE)

 

display flashes.

Solution pump blocked.

out the mains plug. Clean

 

 

the solution pump.

 

If a siphon is connected: Si-

Clean the siphon.

 

phon blocked.

 

 

 

 

Wait until the K (DOOR) dis-

 

 

play lights up green.

 

 

If it is still necessary to open

 

The filling door is locked due

the filling door:

 

turn the program selector to

 

to a high water level or a

I (OFF) turn the program

 

high temperature. The K

 

selector to C (PUMP OUT).

 

(DOOR) display is off.

 

Press the O/s (START/

 

 

 

 

PAUSE) button.

The filling door cannot

 

After the water has been

be opened when the

 

pumped out, the filling door

unit is switched on.

 

can be opened.

 

 

If water can be seen through

 

 

the window in the door, first

 

Power failure!

carry out emergency empty-

 

(All displays have gone off).

ing (see section “Carrying out

 

For safety reasons the door

Emergency Emptying Opera-

 

remains locked for 4 to

tion").

 

10 minutes.

After approx. 4 to 10 minutes

 

 

the door can be opened

 

 

again by pulling the handle.

 

Water valve not fully opened.

Open the water valve fully.

Remnants of detergent

Filter in the screw connec-

Close the water valve. Un-

are building up in the

tion of the intake hose on

screw the intake hose from

detergent drawer.

the water valve or on the

the water tap and from the

 

 

unit is blocked.

unit. Clean the filter.

 

 

 

34

Page 33 Page 35
Image 34
Page 33 Page 35
Contents ÖKO-LAVAMAT 72640 update Please read this user information carefully Tips on using the applianceDear Customer Pass it on to any future owners of the unitContents Installation and connection instructions Warranty conditions / Customer service centres Before Using for the First Time SafetyCorrect Use Safety of Children and Infirm Persons General SafetyDisposing of the Packaging Material DisposalEnvironmental tips Disposing of your old applianceFront view Unit descriptionDrawer for detergent and care agent Program selector Control panelCOTTONS/LINEN Woollens / P Hand Wash Main washing cycle for delicates at 30 C or 40 CIs rinsed in, spin Soaking Additional program buttonsPRE Wash StainConsumption values What does Update mean?Filling Quantity Water Energy Prepare washing cycle Before the first washSort washing and prepare Washing Types and Care Symbols Water softener Detergents and care agents Which detergent and care agent?How much detergent and care agent? Water hardness detailsBrief instructions Run a washing cycleAfter the washing program ends Setting the Washing Program TablesChanging the spin speed Changing the spin speed/Selecting the rinse hold functionSelecting the rinse hold function Set the delay timer / soaking duration Delay timer Soaking durationFor the maximum filling quantities, see the Program tables Opening and closing the filling doorAdd the washing Close the filling door securelyCompartment for pre-wash/soaking detergent If using liquid detergent / tabsAdd detergent/care agent Or for water softenerIf the time preselection is set Start the washing programCompletion of the Washing Program Program sequence displaySelect the additional program Change programChanging or aborting the program Change the Spin SpeedWashing cycle is finished/Remove the washing Program tables WashingWoollens Hand Wash SWOOLLENS RCOLD toSeparate spin Separate conditioning/starching/impregnationSeparate rinse Type of washing Max. Filling quantity Program selectorCleaning and Care Detergent DrawerWashing Drum Main doorProblem Possible Cause Remedy Remedying faultsWhat to do if Intake hose blocked Iron Drainage hose bent Remove the bend If at the end of the last rinse foam is still visible If the washing results are not satisfactoryIf there are still grey spots on the washing If there are white remnants on the washingCarrying out emergency drainage Drain pump When the water is completely drainedBefore cleaning the drain pump Ing pumped out, e.g. if the pump is blockedAdditional Rinse +ÁRINSE+ No additional rinse is set when the unit is deliveredCancel additional rinse To rinse with more waterCan be started Child Safety FeatureCancelling the child safety feature On the inside of the filling doorInstallation and connection instructions Installation Safety PrecautionsRemove transport packaging Installation of the applianceTransporting the appliance Under unitsAre supplied with it Cover the hole with the cap CInstallation on a concrete base Prepare the installation placeInstallation on vibrating floors Compensate for floor unevenness Pensated for by adjusting the adjustable feetDed foot as far as it will go Water connection Electrical connectionPermissible water pressure Water inflow Water drain-off inside a siphon Water drainDelivery heads over 1m Water drain-off inside a basinDimensions in mm Technical dataDimensions = 0.1 1.0 MpaWeitere Kundendienststellen im Ausland Further after-sales service agencies overseasAutres agences étrangères assurant le service après-vente Otros puntos de Postventa en el extranjeroBulgaria Kuwait/Arabian Gulf Australia Korea South NamibiaCroatia New Zealand Cyprus Lebanon OmanThailand Slovakia Rep South Africa Israel Malaysia Saudi ArabiaJapan Singapore Slovenia HungaryWarranty conditions / Customer service centres Page Index Service When do you incur costs even during the warranty period?AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG
Related manuals
Manual 48 pages 2.13 Kb
Top Page Image Contents