AEG 60810 manual Conditioner insert

Page 21

	Problem	Possible cause		Remedy
	Conditioner not rinsed	Conditioner insert in the	Clean the detergent drawer,
	in, w compartment for	compartment for additives	Clean the detergent drawer,
	in, w compartment for	compartment for additives	insert the conditioner insert
	additives is filled with	is not correctly attached or	insert the conditioner insert
	additives is filled with	is not correctly attached or	firmly.
	water.	is blocked.	firmly.
	water.	is blocked.
		Door locked.	Wait until	indicator
		Door locked.	(DOOR) is lit green.
			(DOOR) is lit green.
			The programme will continue
	The door cannot be	There has been a power cut.	when the power cut is over.
	opened when the wash-	There has been a power cut.	To remove washing:
	ing machine is switched	(All indicators are off.)	To remove washing:
	on.	For safety reasons, the door	If water can be seen in the
		remains locked for approx. 4	appliance, before opening
		to 10 minutes.	the door, first drain off the
			water. (See section “Carrying
			out an emergency drain”.)
	Washing is heavily	Possibly too much washing	Observe maximum loads.
	creased.	was loaded.	Observe maximum loads.
	creased.	was loaded.

21

Image 21

Contents Lavamat Dear customer Following symbols are used in the textContents Installation and connection instructions Prior to using for the first time SafetyChild safety Follow the Instructions for installation and connectionThis could constitute a fire hazard through overheating General safetyControl panel Description of the applianceDrain Spin Programme overviewApplication/features Preparing and sorting washing Before the first washPreparing washing Sorting washingRunning a washing cycle Opening the door/Loading the washingAdding detergent/additives Switching on the appliance/selecting a programme Washing powder/tablets for the main washIf you use liquid detergents Selecting the programme options Changing the spin speed/Selecting rinse holdStarting a programme Setting the delay timerInterrupting a programme/Adding washing Programme progressInterrupting a programme Adding washingIf Rinse Hold has been selected End of the wash cycle/Removing the washingReleasing the child safety device Child safety deviceCleaning procedure Cleaning and maintenanceDetergent dispenser drawer Washing drumWhat to do if Door and rubber collarRemedying small malfunctions Let hose fitting is blocked Conditioner insert Washing is grey and scale is being deposited in the drum If the wash results are not satisfactoryThere are grey stains on the washing After the last rinse foam can still be seenCarrying out an emergency drain When the water has all drained awayDrain pump Disposal Packaging materialOld appliance Consumption values Technical dataSafety information for the installation Installation and connection instructionsWhen moving using a sack trolley Installing the applianceTransporting the appliance Removing the transit packagingSeal hole using sealing cap C If the appliance is to stand on a plinth Where to installElectrical connection Connecting to the water supplyMaking the appliance level Permitted water pressureWater inflow Water drainage Pumping heights over 1 mDraining water into a wash basin/bath Autres agences étrangères assurant le service après-vente Further after-sales service agencies overseasWeitere Kundendienststellen im Ausland Otros puntos de Postventa en el extranjeroAustralia Korea South Namibia Japan Singapore Slovenia Page Page Service AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG